Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

H-214
DELUXE PACKING
TABLE
TOOLS NEEDED
7/16" Wrench
Flathead Screwdriver
Phillips Screwdriver
Figure 1
Figure 2
PAGE 1 OF 12
1-800-295-5510
uline.com
ASSEMBLY
Small Dowel
Pour le français, consulter les pages 9-12.
NOTE: Table unit is shipped in two cartons. The
first contains the table top and leg assemblies;
the other contains all the hardware, shelves,
drawer, dowels and brackets.
LEG ASSEMBLY
Leave table top in the box for added protection and
ease of assembly.
1. Attach the right and left leg assemblies to the
pre-attached leg channels. (See Figure 1) Attach
front leg assemblies using 1/4 - 20 x 2" hex bolts,
washers and nuts. Attach the back leg assemblies
using 1/4 - 20 x 4" hex bolts, washers and nuts.
NOTE: Do not tighten 4" bolts.
NOTE: The front of the table can be identified
by the drawer channels that extend to the
front edge.
2. Insert leveling bolts and nuts into legs. (See Figure 2)
3. Insert one small dowel into the nylon bushings
located at the rear of each leg.
Para Español, vea páginas 5-8.
0521 IH-214
Tabla de contenido
loading

Resumen de contenidos para Uline H-214

  • Página 5: Mesa De Alta Calidad Para Trabajo

    H-214 800-295-5510 uline.mx MESA DE ALTA CALIDAD PARA TRABAJO HERRAMIENTAS NECESARIAS Llave de 7/16" Desarmador Plano Desarmador de Cruz ENSAMBLE NOTA: La unidad de la mesa se envía en dos cajas. La primera contiene la cubierta de la mesa y los ensambles de las patas y la otra contiene todos los accesorios, las repisas, el cajón, las barras y los soportes.
  • Página 6: Continuación De Ensamble

    CONTINUACIÓN DE ENSAMBLE CONTINUACIÓN DE ENSAMBLE DE LAS PATAS Soporte Trasero 4. A continuación, fije el soporte posterior que se extiende desde la parte trasera de una pata hasta la otra usando pernos de cabeza hexagonal de 1/4 - 20 x 2". Asegure con una rondana y una tuerca. (Vea Diagrama 3) Barra 5.
  • Página 7 CONTINUACIÓN DE ENSAMBLE ENSAMBLE DE LA REPISA SUPERIOR Y LOS SEPARA- DORES Fije la repisa superior a los soportes. Alinee los orificios de instalación de la repisa superior (3er orificio desde los extremos de la repisa) con los orificios de los soportes. Use tornillos de cabeza Repisa superior redonda de 1/4 - 20 x 5/8"...
  • Página 8: Cortadoras Opcionales (No Incluidas)

    Tuerca con Rondana Estrella #10 - 24 3800 Accesorio de Cortadora Giratorio (Opcional) Tornillo Ranurado de Cabeza Alomada Tuerca con Rondana Estrella #10 - 24 x 2" #10 - 24 693011 3800 800-295-5510 uline.mx PAGE 8 OF 12 0521 IH-214...

Tabla de contenido