Dismantling And Disposal - CAME G03003 Manual Del Usuario

Ocultar thumbs

página de 16

/ 16
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

ATTACHMENT FLANGE FOR SEMI-ELLIPTICAL ARM

Semi-elliptical arm attachment flange complete with flange cover

and barrier arm end-cap.

A - Flange cover

B - Attachment ﬂ ange

C - Mid plate

D - Arm end-cap

E - Semi-elliptical barrier arm L = 3m

F - Anti-impact proﬁ le

G - Channel cover proﬁ les

H -

Luminous cord

I - Luminous cord power supply cable

L - Reﬂ ective adhesive strips

M - Balancing spring Ø 50 mm

N - internal barrier-arm reinforcement

Installation

Calculate the am length (A) and that of the anti-impact proﬁ le (C)

1 -

by using as reference the passage width length (B). If necessary,

trim off any excess.

Fit the reinforcement and the anti-impact proﬁ le into the barrier

2 -

arm; trim any excess proﬁ le.

The luminous cord may be cut only at the points indicated by

3 -

the scissors (i.e. at each meter) .

Length of cord = L x 2 + 0.5 m

Insert the insulation cap into one of the two ends of the luminous

4 -

cord. Insert by pressure the luminous cord into the arm raceway,

as shown in the ﬁ gure.

5 -

Insert the power cable through the central hole in the

transmission arm plate. Perforate the control panel at one of

the pre-perforated points and ﬁ t the cable gland; insert and

connect the cable to terminal 10-E6

6 -

Position the mid plate and the attachment flange to the

transmission shaft, using the screws.Do not tighten the screws

to facilitate the later insertion of the arm.

119GV72

119GV72 ver.1.1

1.1 01/2012

7 - Insert and fasten the arm into the attachment cover, while

being careful about the cord's power supply cable.

Connect the power cable jack to the luminous cord. If the

8 -

luminous cord does not work invert/turn the jack, then isolate

the junction point with a thermo shrinking sheath.

Cut the cable cover proﬁ les to the right length and insert into the

9 -

arm raceway. Procedure to follow on both sides. Secure the cap

to the end of the arm and apply the reﬂ ective adhesive strips.

Insert and fasten the (anti-shearing) ﬂ ange cover onto the arm

10 -

attachment cover , using the screws.

Adjust the balancing screw:

11 -

- unhook the eyelet rod from the bracket (1);

- fully tighten the rod (2);

- fully tighten the spring to the attachment lug (3);

- re-hook the rod to the bracket (4);

- fasten the lug nut to the spring (5);

Release the gearmotor and position the arm vertically, then lock

12 -

it back into place.

Set up the balancing spring:

13 -

- fully tighten the eyelet rod under the spring (1, 2);

- tighten the spring on the anchoring lug which is hooked to the

transmission shaft (3);

- hook the rod to the bracket (4);

Release the gearmotor. Manually turn the balancing spring to

14 -

increase or reduce the traction force so that the arm balances

at 45°.

Fasten the lug nut and lock the gearmotor into place.

15 -

Warning! When balancing procedures are ﬁ nished, LUBRICA-

TE THE SPRINGS WITH SPRAY GREASE!