Cleaning And Maintenance; Incubator Internal Website; Local Network Connection; Internal Website: Homepage - Terragene IC10/20FRLCD Manual De Instrucciones

Incubator internal website

IC10/20FRLCD Auto-reader will be synchronized with the PC's
clock. Synchronization can only be done as long as there is not
an ongoing reading.

Cleaning and maintenance

Cleaning and decontamination of external surfaces
Disconnect the power supply cable and the Ethernet cable from
the incubator. If the device is hot, wait until it has cooled down
before handling it.
Clean the external surfaces of the device using a microfiber
cloth moistened with a solution of mild dish washing
detergent and water. Wring the cloth so it is damp but not
dripping before cleaning, and wipe the outer surfaces of
the incubator. Afterwards, moisten a clean microfiber cloth
with water only, and repeat the procedure until all traces of
detergent are removed from the external surfaces of the
device. After cleaning, allow the Incubator to air dry for at
least 1 hour before connecting the power supply cable or the
Ethernet cable again.
This cleaning procedure can be followed whenever considered
appropriate.
This cleaning procedure must be followed every time a spill occurs
on any of the external surfaces of the incubator.
If further cleaning is required, or if you have doubts about the
cleaning agents you may use, please contact your local distributor.
Do not clean the internal parts of the device.
Do not pour or immerse the device into any liquid. Do
not allow any liquid to run inside the device during
its cleaning.
Maintenance
Bionova IC10/20FRLCD does not require routine maintenance. ®
Incubator internal website

Local Network connection

Bionova IC10/20FRLCD can be connected to a PC for
®
accessing the Incubator internal website, or for connecting
the Incubator to Bionova Bioupdate or Bionova
®
Software. Please follow the next instructions to connect the
Incubator to your Local Ethernet Network:
1.Connect the Incubator to an Ethernet switch or router using
the provided Ethernet cable.
2.Connect your PC to the same Ethernet switch or router using
a suitable Ethernet cable.
3.Verify that the Network connection indicator on the LCD
screen changesfrom to
Incubator has connected to your Local Network successfully.
4.Press on the LCD screen to check the Incubator's
IP Address.
Traceability
®
. This indicates that the
IC10/20FRLCD Page 11
NOTE: The use of Cat. 5e UTP cable (or superior) with
RJ45 connectors is recommended.
NOTE: The device internal website can be accessed
using a Smartphone, Tablet, or any other device that can
run a Web Browser, given that the device is connected to
the same local network as the Incubator.

Internal website: Homepage

After successfully connecting the Incubator to your Local
Network, run a Web Browser on your PC (Firefox, Chrome, etc.)
and type-in the Incubator's IP on the Browser's address bar,
to access the Incubator Internal Website Homepage. On this
screen you will be able to check the status of each position and
the remaining incubation time of all ongoing readings. Also,
from this screen, you can access to the Incubator's Settings
screen, and to the Incubation Results History Screen.

Results history

You can access this page from the homepage or from any
other page, by clicking on the icon
find the history of the last 208 results grouped by 10 per page.
By clicking on Previous or Next, you will be able to scroll all the
results that are stored in chronological order.

Settings

You can access this page from the homepage or from any other
page, by clicking on the icon
language configuration, time zone and time. These parameters
can be configured and synchronized immediately with the auto-
reader.
. On this page you will
. On this page you will find