Replacing The Blade - Uline H-305 Guia De Inicio Rapido

Figure 3
LABEL LAMINATING
Place the label face down (printed side against tape
adhesive) centered on the tape, allowing 1/2" of
exposed tape at the lead end. (See Figure 3) For better-
controlled placement where the same size label is used
continuously, it is suggested that a label be located on
the platform under the tape as a guide.
1. Loosen, but do not remove blade clamp screws to
remove used blade.
2. Platform Unit – Install replacement blade between
platform and front of dispenser with beveled cutting
edge toward tape roll.
Unit – Install replacement blade between blade
clamp and front of dispenser with beveled cutting
edge toward tape roll.
PAGE 2 OF 6
OPERATION
Figure 4
LABEL DISPENSING
Grip the lead edge of the label and tape and pull
straight forward to obtain 1/2" minimum tape length
beyond the label. To cut the tape, pull down onto the
cut-off blade and slightly to one side. (See Figure 4)
The tape and label are now ready for application to
the container.

REPLACING THE BLADE

3. Seat blade on clamp screws while retightening
screws. Blade must not extend beyond ends of
dispenser.
1-800-295-5510
uline.com
Cut-off
Blade
CAUTION! Use care when working near the
blade, as the blade is sharp.
1020 IH-305