Tabla de contenido
Idiomas disponibles
Idiomas disponibles
382957/DW412
5/8/02
9:10 AM
• DON'T ABUSE CORD. Never carry tool by cord or yank
it to disconnect from receptacle. Keep cord from heat,
oil, and sharp edges.
• SECURE WORK. Use clamps or a vise to hold work. It's
safer than using your hand and it frees both hands to
operate tool.
• DON'T OVERREACH. Keep proper footing and balance
at all times.
• MAINTAIN TOOLS WITH CARE. Keep tools sharp and
clean for better and safer performance. Follow
instructions for lubricating and changing accessories.
Inspect tool cords periodically and if damaged, have
repaired by authorized service facility. Inspect extension
cords periodically and replace if damaged. Keep handles
dry, clean, and free from oil and grease.
• DISCONNECT OR LOCK OFF TOOLS when not in use,
before servicing, and when changing accessories, such
as blades, bits, cutters.
• REMOVE ADJUSTING KEYS AND WRENCHES. Form
habit of checking to see that keys and adjusting
wrenches are removed from tool before turning it on.
• AVOID UNINTENTIONAL STARTING. Don't carry
tool with finger on switch. Be sure switch is off when
plugging in.
• EXTENSION CORDS. Make sure your extension cord is
in good condition. When using an extension cord, be sure
to use one heavy enough to carry the current your
product will draw. An undersized cord will cause a drop in
line voltage resulting in loss of power and overheating.
Page 2
2
The following table shows the correct size to use
depending on cord length and nameplate ampere rating.
If in doubt, use the next heavier gage. The smaller the
gage number, the heavier the cord.
Minimum Gage for Cord Sets
Volts
Total Length of Cord in Feet
120V
0-25
26-50
51-100
240V
0-50
51-100
101-200
Ampere Rating
More
Not more
American Wire Gage
Than
Than
0
-
6
18
16
16
6
-
10
18
16
14
10
-
12
16
16
14
12
-
16
14
12
Not Recommended
• OUTDOOR USE EXTENSION CORDS. When tool is
used outdoors, use only extension cords intended for use
outdoors and so marked.
• STAY ALERT. Watch what you are doing. Use common
sense. Do not operate tool when you are tired.
• CHECK DAMAGED PARTS. Before further use of the
tool, a guard or other part that is damaged should be
carefully checked to determine that it will operate properly
and perform its intended function. Check for alignment of
moving parts, binding of moving parts, breakage of
parts, mounting, and any other conditions that may
affect its operation. A guard or other part that is damaged
should be properly repaired or replaced by an authorized
service center unless otherwise indicated elsewhere in
this instruction manual. Have defective switches replaced
by authorized service center. Do not use tool if switch
101-150
201-300
14
12
12
Tabla de contenido
