Cleaning The Well, Basket Support And Accessories; Checking Gas Pressure - Angelo Po 091FR1ID Manual De Uso Y Instalación

To carry out this operation, proceed as follows.
1 - Switch the appliance off and leave it to cool
(see page 12).
2 - Turn off the circuit-breaker to disconnect it from
the electrical mains.
3 - Drain and filter the oil (see page 13).
4 - Remove and clean the baskets and the basket
support structure (A).
5 - Apply a food-grade detergent to the inside of
the well.
6 - Rinse the well with drinking water and drain.
7 - Apply a specific product or a water and vinegar
solution to the well to remove the detergent res-
idues.
8 - Rinse, empty and dry the well.
9 - After use, clean the accessories with a suitable
grease-remover product. If possible, wash in
the dishwasher.
To carry out this operation, proceed as fol-
lows.
1 - Turn off the gas supply tap.
2 - Open the hatch (A).
3 - Undo the screw (B) of the pressure connection.
4 - Connect the pressure gauge (C) to the pres-
sure test point.
IT IT
GB GB
DE DE
FR FR
ES
ES
English

CLEANING THE WELL, BASKET SUPPORT AND ACCESSORIES

CHECKING GAS PRESSURE

B
A
Important
When using water for routine cleaning,
check that there are no traces of water left
in the well, on the accessories and in the
drain line before refilling with oil.
5 - Turn the gas supply tap back on.
6 - Switch on the appliance (see page 9).
7 - Perform a cooking cycle without food at the
maximum temperature then check that the
pressure reading complies with the values pro-
vided in the table at the back of the manual.
A
C
- 16 -
IDM-39615303300.tif
50
48
46
44
40
38 IDM-39619401200.tif
36