18_6.Cleaning Aluminium Parts; 18_7.Cleaning Wooden Parts; 18_8.Inspection Of The Parts; Dismantling The Cabinet - Specialized Technician - Arneg Belgrado TCBM Manual De Instalacion Y Uso

18_6.Cleaning aluminium parts

DO NOT use acid or alkaline detergents (e.g. bleach) which could corrode the
surfaces
DO NOT use rough or abrasive materials or metal scrapers that could scratch
the aluminium surfaces
DO NOT use steam cleaning equipment
DO NOT use dirty cloths
Use a soft cloth with a neutral detergent or soap and lukewarm water (max
30°C).
Immediately remove all traces of water or detergent using a dry cloth in order
to prevent marks from forming.

18_7.Cleaning wooden parts

DO NOT use acid or alkaline detergents (e.g. bleach), soda and solvents
which could corrode the surfaces
DO NOT use rough, abrasive materials which can scratch the surfaces
DO NOT use steam cleaning equipment
DO NOT use rough cloths
Moderate the use of liquid detergent: excessive use can cause infiltrations
between the panel and the edge, with possible swelling of the panel.
Use a soft cloth with a neutral detergent or soap and lukewarm water (max
30°C).
Immediately remove all traces of water or detergent using a dry cloth in order
to prevent marks from forming.
If necessary, before proceeding with treating the entire surface, perform a
preliminary test on a small and hidden area, making sure that the product in
question des not damage the finishings and alter the colour or matt finish.
All the cleaning operations, including the disinfection, the rinse and the drying
must be performed diligently, eliminating any water or detergent residue so as to
avoid the spread of bacteria harmful to health. Parts left to dry with detergent or
disinfectant residues may get damaged.
Remove any element from the pavement such as: sponges, rags, detergent or
water residues that may cause accidental slipping and falls.

18_8.Inspection of the parts

Once you've finished the cleaning, disinfection, rinse, and drying operations,
accurately check that all the parts arew perfectly clean and dry and that they are not
damaged or excessively worn out and, if need be, replace them.
Reassemble the completely dry elements and restore electrical power supply. Once
the internal operating temperature has been reached, it is possible to load the products
to be displayed in the cabinet.

19.Dismantling the cabinet - specialized technician -

The cabinet must be dismantled in compliance to the norms that concern the handling
of wastes foreseen in the individual countries, and in respect of the environment in
which we live in. This product is considered by the Legislature in force to be a
dangerous waste and therefore its separate waste collection is obligatory and it cannot
be treated as domestic waste nor assigned to a waste dump. Before dismantling the
cabinet, it is necessary to provide for the recovery of the refrigerant and to remove the
lubricant oil. This product is made up by 75% of recyclable materials. Materials used in
the manufacture:
- Varnished steel:
- Copper, Aluminium:
- Galvanized steel sheet:
05060145 01 31/08/2015
risers, shelves, feet
refrigeration circuit, electrical system and upper
overhead lights
lower panels, varnished panels, base structure, decks,
trays
Belgrado TCBM-TCPW
English
35