Scan Mode - miniland baby digital camera 1.8 Manual De Instrucciones

ENGLISH
3. Using the UP
4. Confirm the selection pressing the
5. Press the Menu/Back
6. TRANSMISSION LEVEL icon (E) will be displayed at the top of the LCD screen.
5.2.4. CHOOSING THE CAMERA
This product is designed to allow the observation of different areas with up to 4 cameras. To
choose the camera you want to see, follow the next steps:
1. Press the Menu/Back key
2. Press the UP
to enter into the sub-menu.
3. Press UP /DOWN
camera 3, camera 4 or scan mode).
4. Press key go to selected cam.
Note 1: You will only be able to select the cameras that have already been paired with the
monitor.
Note 2: There is a faster way to change the camera you are viewing. Directly press
cycle through paired cameras: CAM1 / CAM2 / CAM3 / CAM4 / SCAN MODE.

5.2.5. SCAN MODE

This function automatically cycles through your paired camera channels to display each camera
for 12 seconds. This function can be used only when you have more than 1 camera unit paired.
To enter in this mode:
1. Press the Menu/Back
2. Press the UP
key enter into the sub-menu.
3. Press UP /DOWN
4. Press key.
Note 1: When one of the cameras is out of range or is not switch on, the monitor will warn you
and the Scan Mode will stop.
Note 2: The Scan mode can be turned on or off by pressing the
main screen.
5.2.6. ADD CAMERA AND PAIRING
The pairing between the monitor and the camera will be done under two circumstances:
- If you want to add an additional camera.
This product is designed to allow the observation of different areas with up to 4 cameras.
- If the CONTROL monitor and the camera are not paired.
The monitor and the original camera leave the factory with channel 1 programmed, nonetheless,
if for some reason, they are not, you can link them manually following the steps indicated below.
To pair the camera and the monitor follow the next steps:
1. Press the MENU/Back
2. Press UP key or DOWN
into the sub-menu.
3. Press UP /DOWN
4. Press key to search for a camera unit. The power LED indicator (2) will begin to flash in
green.
5. While the LED indicator is flashing, press the link button on the camera (VI).
6. Once paired, the LED indicator will stop flashing and the image of the camera will show
immediately on the monitor unit screen.
7. If unsuccessful, please repeat above steps.
For various reasons you may lose the connection between the monitor and a camera which is
already connected. Should this be the case, repeat the process explained above to connect the
key or DOWN key, select the transmission level desired: HIGH or LOW.
key to return to the main screen.
and the menu icon will pop up.
or DOWN key until the camera icon
key to select the desired camera to view (Camera 1, camera 2,
key and the menu will pop up.
key or DOWN key until the camera icon
key to select the scan camera icon
key and the menu will pop up.
key to select ADD camera icon
key to select the desired camera to add.
key.
14
is highlighted then press OK key
is highlighted then press
.
button while viewing the
then press
key to
key enter