Tabla de contenido
Idiomas disponibles
Idiomas disponibles
PadPak
LC
®
Guard System
EN
In the exit chute of the converter, there is a guard system.
This guard prevents you from reaching your hand from the
outside into the cutting blades and the perforating wheels
while the converter is activated.
Converter Warnings
The warnings attached to the converter must remain visible
and legible at all times. Ask your distributor to replace them
when necessary. Do not block or cover any of the warnings.
Further information on the labels is included in Section 4
"Converter Labels"
Warnings in this document
i
Caution!
Warning!
Warning!
Do not place hands inside the converter
Dangerous Substances for Humans and
the Environment
Emission during Operation
The converter does not produce any harmful exhaust
fumes during operation. The converter does not contain
any substances that may yield dangerous emissions. The
converter can produce paper dust during operation, ensure
sufficiently ventilation
Protection of the Environment
The environment can be endangered by:
•
Oil in the speed reducer of the drive system
•
Oil or grease in the bearings of the converter
•
Grease used when mounting screws and bolts in
aluminium parts
•
A back-up battery in the control box
These substances must be treated as chemical waste for
which the regulations of the local law apply. Although it
is not permitted to work on the converter yourself, under
certain circumstances, it may be necessary to remove
or replace one of the substances mentioned above. To
these, the local regulations apply. When replacing these
substances, use the recommended or supplied type from
the manufacturer, Ranpak.
ii
A note with additional information
The product can be severely
damaged
You can injure yourself or severely
damage the product
Pay attention to sharp edges,
corners and knives of the converter
due to the risk of cutting.
Calamities
There are no special regulations for calamities. In case of
fire, use a normal extinguishing agent. When extinguishing
with water, ensure the power voltage is turned off.
Moving the Converter
•
Switch the converter off
•
Remove the power plug from the wall socket
•
Collect any loose cords
•
Unlock the wheels and move the converter to the
required location
•
Once in position, lock the wheels using the built-in
brakes.
Be careful:
The converter weighs ± 103 kg (220 lbs.)
The converter can be top-heavy.
Warning!
Ensure that the cords cannot be
damaged. Pay special attention to areas
where people work with vehicles (such
Warning!
as forklift trucks).
In general
Before performing maintenance on the converter, the
electrical supply must be turned off by pulling the power
plug from the wall socket.
Pay attention to sharp edges, corners
and knives of the converter due to the
risk of cutting.
Warning!
Do not operate the converter when
the safety
devices
removed.
Warning!
PadPak PPLC2 Operator Manual - EN
are switched off or
Capítulos
Tabla de contenido
Solución de problemas
