Battery Charger - GreenWorks 2101202 Manual Del Propietário

BATTERY CHARGER

CHARGING PROCEDURE
The battery is not shipped fully charged. It is recommended to fully charge before first use
NOTE:
to ensure that maximum run time can be achieved. This lithium-ion battery will not develop a memory
and may be charged at any time.
Low voltage charging:
If the battery has been stored with little to no charge for a long period of time, the charger will go into
recovery mode, which will take 20 hrs to fully charge the battery. This will enhance the life of the battery.
Once it is fully charged, the next charge will return to standard charging.
A fully discharged battery pack will require the allotted time as stated in the battery manual. Plug the
charger into an AC power outlet.
Insert the battery into the charger.
•
This is a diagnostic charger. The Charger LED Lights will illuminate in specific order to communicate
h t e c r u e r t n b t a e t y r
Fig. 15
False defect note:
When the battery is inserted into the charger and the status LED blinks RED, remove the battery from
the charger for 1 minute, then reinsert. If the status LED blinks GREEN, then the battery is properly
charging. If the status LED is still blinking RED, remove the battery and unplug the charger for 1 minute.
After 1 minute, plug in the charger and reinsert the battery. If the status LED blinks GREEN, then the
battery is properly charging. If the status LED is still blinking RED, the battery is defective and needs to
be replaced.
(See Figure 15. )
s a t u t . s T h e y a e r a s o f o l l w : s
Charging
LED STATUS
Blinking Green
Solid Green
Solid Red
Blinking Red
21
Fully Over
Charged Temperature
DESCRIPTION
Charging
Fully Charged
Over Temperature
Charging Fault
Charging
Fault