Battery & Charger Maintenance; Charging Procedure - GreenWorks ST24B01 Manual Del Propietário

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

BATTERY & CHARGER MAINTENANCE
CHECKINg BATTERY CAPACITY
Press the battery capacity indicator (BCI) button. The lights will illuminate according to the
batteries capacity level. See chart below:
LIGHT METRE
3 Green Lights
2 Green Lights
1 Green Light
Lights go out

CHARgINg PROCEDuRE

NOTE: The battery is not shipped fully charged. It is recommended to fully charge before first use to ensure
that maximum run time can be achieved. This lithium-ion battery will not develop a memory and may be
charged at any time.
1. Plug the charger into an AC power outlet.
2. Insert the battery pack (1) into the charger (2).
This is a diagnostic charger. The Charger LED Lights (3) will illuminate in specific order to
communicate the current battery status. They are as follows:
NOTE: When the red indictor flickers, pull out the battery from the charger and insert again
within 2 hours. If the indictor shows charging, that means the battery is good. After 2 hours,
please pull out the battery and also pull out the AC power plug of the charger for 1 miniute, and
then insert the AC power plug and the battery again. If the indictor shows charging, that means
the battery is good. If not, the battery needs to be changed.
Lights
3
2
1
Capacity
The battery is at 80-100% capacity
The battery is at 50-80% capacity
The battery is at 20-50% capacity
The battery is under 10% capacity and
requires charging immediately
CHARGING PROCEDURE (LED INDICATOR)
BATTERY IS CHARGING:
fULLY CHARGED:
BATTERY IS TOO WARM:
(REMOVE fOR APPROX. 30
MINUTES TO ALLOW TO COOL)
NO BATTERY PRESENT
DEfECTIVE BATTERY:
(REMOVE AND REPLACE WITH
NEW BATTERY If THIS OCCURS)
20
BCI BUTTON
BATTERY METRE
GREEN BLINKING
GREEN
Off
Off
Off

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido