Klarstein 10010176 Manual Del Usuario página 22

Disassembly
• Once the beer keg has been emptied, remove the CO2 cartridge from the dispenser first. To do this, unscrew
the CO2 cartridge holder (13) from the CO2 cartridge connector (10).
• WARNING! Any leaking CO2 is very cold! Danger of frost bite!
• Please note: Put a full beer keg into the dispenser before inserting a new CO2 cartridge.
• Push the button (17) on the dispenser to open the lid (1).
• Pull the CO2 connector (20) out of the CO2 feed valve (19) at the back of the dispenser.
• Remove the empty beer keg with the dispensing unit (3) from the dispenser.
• Place the beer keg with the dispensing tap next to a wash basin and let the remains of the beer run out.
Press the keg release plastic lever on the front
clamp to release it (fig. 8).
Now press the dispensing unit (3) forwards to re-
lease the back clamp (fig. 10).
Pull the dispensing unit (3) a little backwards and
upwards, to release the front clamp (fig. 9).
Pull the dispensing unit (3) straight up out of the
beer keg to prevent damaging the connecting tube
(26) (fig. 11). Warning: Only remove the dispensing
unit (3) from the keg when it is no longer pressu-
rized. Should there still be pressure in the beer keg,
then let the beer remains flow out first before deta-
ching the dispensing unit from the beer dispenser.
Clean the appliance as described in Cleaning and
Care.
22