Replacing The Oven Light Bulb - Bosch HMT35M653 Instrucciones De Uso

Problem
The microwave does not switch
on.
It takes longer than before for the
food to heat up.
An audible signal sounds. The
colon in the display flashes.
Error messages
You can take remedial action yourself for some error
messages.
Error message
Error message "Er1", "Er4", "Er18" or "E305"
appears in the display.
Error message "Er11" appears in the dis-
play. "Button jammed"

Replacing the oven light bulb

It is possible to replace the oven light. Heat-resistant 240 V,
25 W halogen bulbs can be obtained from after-sales service
or a specialist retailer.
:
Risk of electric shock!
Never replace the oven light when the appliance is switched on.
Pull out the mains plug or switch off the appliance at the circuit
breaker in the fuse box.
Note: Always remove the new halogen bulb from the packaging
using a dry cloth. This increases the service life of the bulb.
Method
Note: You must remove the whole appliance in order to replace
the cooking compartment light. Follow the installation
instructions.
Unplug the appliance from the mains or switch off the circuit
1.
breaker in the fuse box.
Open the appliance door.
2.
Undo the securing screws on the right and left-hand side of
the oven. Follow the installation instructions.
Carefully lift out the appliance.
3.
4. Undo the screw from the light cover on the outer left-hand
side wall and remove the cover. (Fig. A) Pull out the halogen
light. (Fig. B).
10
Possible cause
The door was not fully closed.
n
The button has not been pressed.
The microwave power setting is too low.
A larger amount than usual has been placed
in the appliance.
The food was colder than usual.
The appliance is in demonstration mode.
Possible cause
Technical malfunction.
The buttons are dirty or the mechanism
has jammed.
Remedy/information
Check whether food remains or foreign material
is trapped in the door. Make sure that the seal-
ing surfaces are clean. Check whether the door
seal is twisted.
n
Press the
Select a higher power setting.
Double the amount = almost double the time
Stir or turn the food during cooking
1. Press the
2. Press and hold the
onds.
The demonstration mode is deactivated.
Remedy/Note
Call the after­sales service.
Press all the buttons several times. Clean
the buttons with a dry cloth. Open and
close the appliance door. If this does not
help, consult the after-sales service.
$
Insert the new halogen bulb (Fig. C)
5.
&
Screw the lamp cover in place.
6.
Reassemble the appliance in the reverse order.
7. Switch the circuit breaker in the fuse box back on or plug in
the mains plug.
Replacing the glass cover
If the glass cover in the oven is damaged, it must be replaced.
You can obtain covers from the after-sales service. Please
supply your appliance's E number and FD number.
button.
2
button.
button for three sec-
`
%