Introduction; General; Safety And Precautions; Environmental Markings - Isotherm DR 49 Instrucciones De Instalacion Y De Uso

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 32

1. Introduction

1.1 General

Isotherm refrigerators are specially designed to
operate in tough marine environments. They are
fi tted with a fully hermetic, leak-free compressor,
they offer the lowest possible power consumption
and noise level. All models are simple to install. They
can withstand an angle of heel up to 30°, for a short
time. To ensure that your Isotherm fridge operates as
effi ciently as possible, please follow these general
guidelines:
• Unnecessary opening of the fridge door will increase
power consumption.
• Good ventilation of the compressor and condenser
unit will reduce power consumption.
• The electrical system should be in good condition.
Inspect batteries and charging levels regularly.
Always use a separate starter battery for the engine.
Follow carefully the guidelines regarding electrical
cable areas and fuse placements.
• Keep the inside of the fridge and freezer clean and
dry. Remove any water from condensation that may
have collected in the drip tray.
• Keep the door slightly open to air the refrigerator
when leaving the boat for any length of time.
• Clean the inside of the refrigerator with lukewarm
water and a mild detergent before taking the fridge
into operation the fi rst time.

1.2 Safety and precautions

For your own and others safety, read this fi rst.
Danger! When connected to mains power,
ensure that the power supply is equipped with
an earth safety automatic switch, a "ground fault
circuit interrupter".
Danger! Never touch bare electrical wiring
connected to the AC power supply.
Do not use the device if the connector cables
show visible damage.
Never connect battery charger direct to the
refrigeration system.
A battery charger must be connected to the
battery, never direct to the refrigeration system.
Danger! In addition to acid, a newly-charged
battery contains explosive gas.
Never cover the ventilation openings for the
compressor unit.
Refrigerant may never be let out in the air.
Repair of the refrigeration circuit must be done by
a certifi ed technician.

1.3 Environmental markings

This appliance is marked according to the European
directive 2002/96/EC on Waste Electrical and
Electronic Equipment (WEEE). By ensuring this
product is disposed of correctly, you will help prevent
potential negative consequences for the environment
and human health, which could otherwise be caused
by inappropriate waste handling of this product.
The symbol
on the product, or on the documents
accompanying the product, indicates that this product
may not be treated as household waste. Instead it
shall be handed over to the applicable collection point
for recycling of electrical and electronic equipment.
Disposal must be carried out in accordance with local
environmental regulations for waste disposal.
For more detailed information about treatment,
recovery and recycling of this product,
please contact your local city offi ce,
your household waste disposal service
or the shop where you purchased the
product.
2
Tabla de contenido
loading

Este manual también es adecuado para:

Dr 65

Tabla de contenido