Barrette EPN-52062-WEB Instrucciones De Instalación página 3

Bisagra estándar para puertas de malla metálica/granja
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

1.
Determine Gate Opening:
Gate opening is determined by width of gate plus
clearance for hinge (2") plus clearance for
latch (see latch instructions for details) (Fig. 1).
2.
Mount Hinge on Gate:
NOTE:
Gate can be adjusted to swing up to 160º. When
mounting gate on left gate post, head of tension
adjustment pin and "+ or -" symbol on hinge
should be facing up. Hinges have a self-closing
feature, which can be disabled if desired (see
hinge tension adjustment).
a. Place hinges at desired positions on gate
upright with a minimum spacing of 32" between
each hinge.
b. Remove nuts from 13⁄8" U-clamps and slide
ends of U-clamps through mounting holes in
gate plate, as shown (Fig. 2).
NOTE:
If gate upright is larger than 13⁄8" in diameter,
you must purchase the appropriately sized
U-clamp, nuts and washers.*
c. Thread nuts onto U-clamp ends and tighten
with 9⁄16" or 14 mm wrench (Fig. 3)
3.
Mount Gate on Post:
NOTE:
Both gate posts must be plumb and level prior
to gate installation.
a. Position gate at desired height on post.
b. Measure space between ground and bottom
of gate and cut (2) wood spacer blocks for this
height (Fig. 4).
c. Rest gate on the spacer blocks (Fig. 4).
d. Remove nuts from the 21⁄2" U-clamps and slide
ends of U-clamps through mounting holes in
post plate, as shown (Fig. 5)
NOTE:
If post is less than 21⁄2" in diameter, you must
purchase the appropriately sized U-clamp, nuts
and washers.*
e. Thread nuts onto U-clamp ends and tighten
with a 9⁄16" or 14 mm wrench (Fig. 5).
Fig. 1
Determine location and
gate opening before
installing fence.
Fig. 2
Fig. 3
Gate Upright
Gate Upright
Fig. 4
Wood spacer blocks
Fig. 5
3
Tabla de contenido
loading

Tabla de contenido