Installation; What This Chapter Contains; Mounting - ABB RVT Serie Instrucciones De Instalación Y De Funcionamiento

—

2 Installation

2.1 What this chapter contains

This chapter gives instructions to mount the controller on the panel and explains how to
make the electrical connection to the controller. The wiring diagram is shown in section
2.4.

2.2 Mounting

Please follow steps below to mount a RVT controller to a panel.
Step 1: Slide the RVT (a) perpendicularly to the Capacitor Bank Cubicle (b).
Step 2: Rotate the RVT to insert it into the Capacitor Bank Cubicle.
Note: cut out dimensions are 138x138 mm.
Step 3: Insert the Mounting Bracket (c) in the corresponding Fixation Holes (d) of the
RVT.
Step 4: Pull the Mounting Bracket backwards.
Step 5: Turn the Screw (e) into the Mounting Bracket and tighten until the RVT is secured
in place.
10 Installation ç Manual Power Factor Controller RVT
Step 2
(b)
Figure 5: Mounting a RVT
(a)
Step 1