Installation - Glacier bay HD67109W-8004 Guía De Uso Y Mantenimiento

Installation

1
Installing the faucet assembly
CAUTION: Always shut off the water supply before removing an existing faucet or replacing any part of a faucet. Open the faucet handle
to relieve water pressure and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old faucet. Clean the mounting surface.
□
Remove the preassembled lock nuts (D) and washers (B & C) from the new faucet (A).
1a
NOTE: This step is
you insert the lift rod (Q), the lift rod (Q) can go through the
faucet (A) and down into the slot of the washers (B & C).
□
Before installation, ensure that the ange (E) is
placed on the bottom of the new faucet (A).
□
Place the faucet (A) through the mounting holes
in the sink until the faucet (A) sets on top of the
sink.
□
From underneath sink, secure the faucet
assembly (A) with the rubber washer (B), metal
washer (C) and nuts (D). Use the wrench to
tighten the nuts (D).
B
C
D
for ange installation (optional). When
A
E
1b
NOTE: This step is for escutcheon installation (optional).
If the sink is uneven, use silicone under the gasket (R).
□
Before installation, remove the ange (E) and
bolts (F).
□
Secure the deck plate
the faucet (A) with the screws (T).
□
Place the faucet (A) through the mounting holes
in the sink. Secure the faucet (A) to the sink using
the mounting nuts (S) provided. Hand-tighten only.
1
F
4
(G) and gasket (R) to
A
A
E
3
T
A
5
S
G
R