Changing The Sound And Beep Tone; Selecting The Spectrum Analyzer; Changing The Brightness Of The Display; Auto Dimmer - Sony WX-C5000 Manual De Instrucciones

Changing the sound and
beep tone
Boosting the bass sound — D-Bass
You can enjoy clear and powerful bass sounds.
The D-bass function boosts the low frequency
signal with a sharper curve than conventional
bass boost.
You can hear the bass line more clearly even if the vocal sound is the same volume. You can
emphasize and adjust the bass sound easily.
0dB
Adjusting the bass curve
Press (D-BASS) repeatedly to select the
desired bass curve.
Each time you press (D-BASS), the bass
curve changes as follows:
B D-BASS 1
No display (Cancel) b
As the D-BASS number increases so does
the effect.
To cancel the effect, press (D-BASS) repeatedly
until "D-BASS" disappears.
Note
The bass sound may distort at same volume. If the
bass sound distorts, select less effective bass curve.
Turning off the beep tone
Press (6) while pressing (SOUND).
To obtain the beep tone again, press these
buttons once more.
16
D-BASS 3
D-BASS 2
D-BASS 1
Frequency (Hz)
B D-BASS 2 B D-BASS 3
Selecting the spectrum
analyzer
The sound signal level is displayed on a
spectrum analyzer. You can select from 8
display patterns.
During playback, press (SA) to select a
desired setting.
Each time you press (SA), the setting
changes as follows:
B SA–1 B SA–2
SA* b
* Patterns SA-1 to SA-8 appear for 10 seconds
each in sequence.
Adjusting the spectrum analyzer
level
You can select from three spectrum analyzer
levels.
During playback, press (SA) for two
seconds.
Each time you press and hold (SA) for two
seconds, the displayed item changes as
follows:
B L–1 B L–2*
* Factory pre-setting
Changing the brightness of
the display automatically

— Auto dimmer

If the illumination control lead is connected to
the car's illumination signal, the display will
be dimmed when you turn the lights on.
B SA–3
SA–8 b ... b
B L–3