Makita AD03 Manual De Instrucciones página 7

ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing drill bit
Optional accessory
For model AD03
► 1 . Chuck key
To install the drill bit, place it in the chuck as far as it will
go. Tighten the chuck by hand. Place the chuck key in
each of the three holes and tighten clockwise. Be sure
to tighten all three chuck holes evenly.
To remove the drill bit, turn the chuck key counterclock-
wise in just one hole, then loosen the chuck by hand.
After use, return the chuck key to the storage cavity on
the tool.
For model AD04
► 1 . Sleeve
Hold the tool firmly and turn the sleeve counterclock-
wise to open the chuck jaws. Place the drill bit in the
chuck as far as it will go. Hold the tool firmly turn the
sleeve clockwise to tighten the chuck.
To remove the drill bit, hold the tool firmly turn the
sleeve counterclockwise.
Installing hook
1
► 1 . Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool. To install
the hook, insert it into a groove in the tool housing on
either side and then secure it with a screw. To remove,
loosen the screw and then take it out.
Chuck key holder
1
For model AD03 only (optional accessory)
► 1 . Chuck key holder 2. Screw
1
To install the chuck key holder, fix it to the convex por-
tion of the tool housing on either side and then secure
it with a screw. To remove, loosen the screw and then
take it out.
7 ENGLISH
2
3
1
2