Precor AMT 733 Referencia Rápida página 11

Clean the running belt and deck (treadmill only)
Before you begin the cleaning procedure, check that the safety stop key works correctly.
CAUTION DO NOT stand or allow others to stand on the treadmill running belt during this procedure.
To make sure the safety stop key works:
1. Stand to one side of the treadmill.
2. Make sure that the stop key lanyard is hanging straight down and is not wrapped around the handle bars.
3. Press QuickStart and wait for the running belt to begin moving.
4. Press the safety stop key.
5. The running belt should stop immediately. When it stops, reset the safety stop key.
CAUTION If the running belt does not stop, turn off the treadmill power using the On/Off switch at the front of the treadmill and unplug the
power cord. The treadmill must remain out of service until the stop switch is repaired. Place an "out of order" sign on the treadmill
and contact Precor Customer Support.
6. Turn the treadmill power switch to Off. The On/Off switch is located at the front of the treadmill.
To clean the treadmill belt and deck:
1. Make sure the treadmill is turned off.
2. Take a clean, dry cotton towel that is at least 36 in. (2 m) long and fold it in half
lengthwise.
3. Lift the running belt up and push the towel under the belt. Make sure a few
inches of towel extend over the deck trim on each side.
4. Push the towel forward to the front of the machine so it is located beneath the
safety stop key.
5. Turn the power switch to On.
6. Step onto machine by standing on the side rails and attach the stop key lanyard
to your clothes.
Important
DO NOT stand on the running belt at any time.
7. Stand firmly on both ends of the towel keeping your feet off of the treadmill running belt (Figure 2). Brace yourself using the handlebars or side hand rails.
Figure 2
11