In The Case Of Technical Problems; The Machine Does Not Start Up; Chain Does Not Run; Repair Service - AL-KO Solo 621 Manual De Instrucciones

• Do not store the saw outdoors or in damp and moist
areas.
• Check all the chain saw parts, in particular the chain,
bar and sprocket, of wear after every use.
• Ensure that the chain tension is correct. If the chain
is too loose, it may come off during use and lead to
injuries. The chain must be replaced immediately if it
is damaged. The cutting teeth must be at least 4 mm
long.
• Check the motor housing and power cable after every
use for damage. If there is any sign of damage, have
the chain saw checked by a specialised workshop.
• Check the oil level and lubrication of your chain
saw after every use. Insuffi cient lubrication leads to
damage to the chain, bar and motor.
• Check how keen the chain is every time before you
use the chain saw. A blunt chain will cause overheating
of the motor.
• Sharpening a saw chain requires experience and spe-
cialised knowledge. We therefore recommend to have
sharpening carried out by a specialised workshop.

7. In the case of technical problems

• The machine does not start up: Check whether the
current socket is live. Check whether the power cable
is undamaged. If neither case applies, take the chain
saw to a specialised workshop.
• Chain does not run: Check position of handguard
(see ill. 7). Chain only runs if handguard brake is
released.
• Oil does not f ow: Check the oil level. Clean the oil
fl ow openings in the bar (see also the corresponding
hints of "Maintenance and servicing). If this is not
successful, take the chain saw to a specialised work-
shop.
Attention: Any maintenance or repair work
going beyond that described in these Operating
Instructions may only be carried out by autho-
rised persons or a specialised workshop.
Attention: If the power supply lead of this
device shows any defects, the lead must be
replaced by an authorized repair shop only or
a specialised workshop , as this work requires
special tools.

8. Repair Service

Repairs to electric power tools should only be carried out
by specialist electrical personnnel.

9. Waste disposal and environmental protection

If your device should become useless somewhere in the
future or you do not need it any longer, do not dispose
of the device together with your domestic refuse, but
dispose of it in an environmentally friendly manner.
Please dispose of the device itself at an according collec-
ting/recycling point. By doing so, plastic and metal parts
can be separated and recycled. Information concerning
the disposal of materials and devices are available from
your local administration.

10. Warranty

For this electric tool, the company provides the end user
- independently from the retailer's obligations
resulting from the purchasing contract - with the following
warranties:
The warranty period is 24 months beginning from the
hand-over of the device which has to be proved by
the original purchasing document. For commercial use
and use for rent, the warranty period is reduced to
12 months. Wearing parts and defects caused by the use
of not fi tting accessories, repair with parts that are
no original parts of the manufacturer, use of force, stro-
kes and breaking as well as mischievous overloading
of the motor are excluded from this warranty. Warranty
replacement does only include defective parts,
not complete devices. Warranty repair shall exclusively
be carried out by authorized service partners or a spe-
cialised workshop. In the case of any intervention of not
authorized personnel, the warranty
will be held void.

EC declaration of conformity

The EC declaration of conformity on a separate piece of
paper forms part of this original instruction.
GB-8