Tabla de contenido
Idiomas disponibles
Idiomas disponibles
CLOTHING
- Do not wear loose fitting clothing or jewelry which may get caught in moving parts.
- Hearing protective devices must be worn when using a parts.
WORKPLACE
- Keep the workplace and surroundings clean.
- Kept spectators, especially children, away from the working area..
- Avoid using the machine in a wet area.
- If the use of a tool in a damp location is unavoidable, use a supply protected by a residual
current device (DRC).
CABLE AND PLUG
- Never pull on the wire to unplug the machine from a wall outlet.
- Avoid any contact by the cable with oil, grease or rough surfaces.
- Disconnect your machine: when they are not in use, before any maintenance, and for
changing accessories such as shanks, bits and blades...
POWER
- Plug this machine into a domestic socket.
Insure that the power source corresponds to that indicated on the manufacturer's data
plate.
- Check hoses, hydraulic lines and shutdown devices if your machine is equipped.
Stop the machine immediately in the case of:
- Defective plug or electrical cord or if the cord is damaged.
- Defective switch.
- Excessive amount of sparks from the brushes in the commutator, if the motor have
brushes.
- Smoke or strong odour caused by burning insulation materials.
WIRE SECTION
- Check the relationship between the length of the cable and wire section. Not enough
section causes voltage to be reduced, which later provokes problems with the engine.
Respect the following indications:
- Cable length up to 15 m: 1.5 mm
- Cable length from 15 m to 40 m: 2.5 mm
Read these instructions carefully and keep for future reference.
Warning! To reduce the risk of accident, electrical shock or bodily injury when using
power machines, it is
recommended to always observe basic safety precautions, including the following.
601221-2-Safety Manual-J.indd 39
601221-2-Safety Manual-J.indd 39
1. SECURITY MEASURES
wire section
2
wire section
2
2. GENERAL SAFETY RULES
39
EN
30/06/2020 12:18
30/06/2020 12:18
Tabla de contenido
