Mask Area Setup; Tampering Alarm - Steren CCTV-965 Manual De Instrucciones

After adjusting, in the "Image Setup" menu, press the "Confirm" button to save the parameters. Otherwise, press the
"Cancel" button or the [ESC] key to abort modification.
In some cases, you might want to mask a special area. This area will not be previewed and recorded. The mask area setup
steps are as follows:
- Enter the "Camera" menu and select a camera using [↑][↓] keys..
- Enter the "Advanced settings" and enable the check box beside the "Privacy Mask" item. You can press [ENTER] or the
[EDIT] to do this. Move the "Active Frame" to the "Area" button and press the [ENTER] to enter mask area setup interface.
- The screen will show as blue divided in small squares, one of them yellow. You can use [↑][↓][→][←] keys to move the
yellow square. Once you got to the desires position, press [EDIT], the yellow square will be turned into red. Use [↑][↓][→]
keys to extend the red pane and [←] key to shrink it. This red area is the mask area.
After the red mask area is selected, press the [EDIT] key to save the selected area. You can setup up to 4 mask areas for
each camera.
- Alarm time. You can set six alarms per day. You may copy the different times for different days.
Note: Periods cannot be the same. Please restart the DVR in order to take changes effect.
-Set alarm policy. If there is a modification in the alarm during configured period, the DVR will respond using the policy. You
can select several options: "screen message", "audible message", "back to the centre" or "start external alarm". Remember,
the symbol for enabled mode is
-Save alarm settings. To save configuration, press "confirm" in image setting menu. You can repeat the process for all cameras.

Mask Area Setup

Tampering alarm

, whilst disabled is X.
If you enable this function when someone blocks the
camera, the DVR will show a visual alarm in status bar.
- Click on camera
- Select one camera using [↑] [↓] buttons and select
advanced settings.
- Select sensitivity. Move the Current Window to sensitivity
box (near to vision block). Press EDIT to select sensitivity.
Use [↑] [↓] to choose between low, normal or high. Select
one of the options to activate menus in "area setting" and
"policy"..
- Move the Current Window to Area button and press
ENTER to get access to the setting interface. Configuration
methods are the same as shadow alarm. Press ENTER to
confirm.
23