Testing The Operation; Testing The Rangetop Burners; Flame Characteristics - Bosch HDIP056U Instrucciones De Instalación

en-us Testing the operation
Position the warming drawer in front of the drawer hous-
2.
ing. Align the rail with the plastic rail tip to the ball car-
rier slide.
Keep the drawer assembly level and square to the
3.
housing and gently insert the drawer to the housing, un-
til a slight increase in resistance is felt at the approxi-
mate position shown below.
Notes
¡ A slight side-to-side wiggle motion may be required to
properly get the ball bearings to accurately align.
¡ If more than a moderate force is required to insert the
drawer, remove the drawer and repeat the installation
procedure.
Push the drawer in fully. An audible "click" should be
4.
heard when the drawer is properly closed causing the
drawer to lock in the closed position.
9.2 Flame characteristics
The color of the flame tells you if the gas supply is properly adjusted.
Note: Allow the appliance to operate for 4 to 5 minutes before evaluating the flame. Some yellow streaking is normal dur-
ing the initial startup.
18
9 Testing the operation

Testing the operation

Check if your unit is working properly after you have com-
Testing the operation
pleted the installation steps.
Turn on power at the breaker.
1.
To test the oven select the Bake mode. See the User
2.
Manual for detailed operating instructions.
Verify that the oven light comes on and the oven begins
3.
to preheat.
To test the door lock set the Self Clean mode. Confirm
4.
that the door locks when the lock icon appears in the
display.
9.1 Testing the rangetop burners
Each burner must be tested for proper lighting and proper
flame characteristics on the lowest and highest power
level.
Test all rangetop burners for proper ignition.
1.
Push down the knob and turn it counter-clockwise to
‒
the ignition symbol ⁠ .
Verify that the igniter/spark module clicks.
‒
Once the air has been purged from the supply lines,
‒
verify that the burner lights within four (4) seconds.
When the burner lights, turn the knob back to the off
position.
If any of the burners do not ignite, do not continue
‒
testing. Call Customer Service.
Test all rangetop burners for flame characteristics on
2.
the lowest setting.
Push down the knob and turn it counter-clockwise to
‒
the ignition symbol . Keep it pushed down until the
burner ignites.
Turn the knob quickly to the lowest setting.
‒
Verify that the flame is a minimum height of approxi-
‒
mately ¼" (6 mm).
Verify that the flame is steady. The flame should not
‒
go out, lift or blow off of the burner. It should carry
over, or surround the entire burner.
Verify that the flame is the right color.
‒
→ "Flame characteristics", Page 18
If the flame goes out, does not carry over properly or
‒
is too large, contact Customer Service.
Test all rangetop burners for flame characteristics on
3.
the highest setting.
Push down the knob and turn it counter-clockwise to
‒
the ignition symbol . Keep it pushed down until the
burner ignites.
Turn the knob to the highest setting.
‒
Verify that the flame is steady. The flame should not
‒
go out, lift or blow off of the burner. It should carry
over, or surround the entire burner.
Verify that the flame is the right color.
‒
→ "Flame characteristics", Page 18
If the flame burns yellow or does not carry over prop-
‒
erly, contact Customer Service.