Tabla de contenido
Idiomas disponibles
Idiomas disponibles
SPECIFICATIONS:
TIME----------------------------------------------------
SPEED-------------------------------------------------
DISTANCE--------------------------------------------
CALORIE--------------------------------------------
FUNCTION KEY:
MODE: Press to select a function. (Time, Speed, Distance, Calorie).
Press and hold the MODE button for 3 seconds to reset time, distance, and calorie.
OPERATION PROCEDURES:
AUTO ON/OFF:
If you begin exercising or press the MODE button, the computer will turn on. After about 4 minutes of inactivity, the
computer will automatically shut off.
RESET:
The computer can be reset by pressing and holding the MODE button for 3 seconds. Removing the batteries will also
reset the computer and return all function settings back to zero.
MODE:
To select the LOCK MODE setting, press the MODE button when the pointer is on the function you wish to display
begins to flash, then remove your finger from the button. Once locked, only the selected function will be displayed.
FUNCTIONS:
TIME: Counts the total time of an exercise from start to finish.
SPEED: Displays the current speed being obtained.
DISTANCE: Counts the total distance of an exercise from start to finish.
CALORIE: Counts the number of total calories burned during an exercise from start to finish.
SCAN: Automatically displays functions in the following order: Time, Speed, Distance, Calorie (repeat).
BATTERY: This computer uses two AA batteries. If there is a problem with the display, please install new batteries.
BATTERY INSTALLATION:
1. Take out 2 AA batteries from computer box.
2. Press the buckle of the battery cover on the back of the Computer (No. 8), and then remove battery cover.
3. Install 2 AA batteries into the battery case on the back of the Computer (No. 8). Pay attention to the battery + and –
ends before installing.
4. Press the buckle of the battery cover, then put the battery cover back to the back of the Computer (No. 8).
The installation is complete!
BATTERY REPLACEMENT:
1. Press the buckle of the battery cover on the back of the Computer (No. 8), then remove the battery cover.
2. Remove the 2 old AA batteries in the battery case and install 2 new AA batteries into the battery case on the back of
the Computer (No. 8). Pay attention to the battery + and – ends before installing.
3. Press the buckle of the battery cover, then put the battery cover back to the back of the Computer (No. 8).
The replacement is complete!
NOTE: Always change both batteries at the same time. Do not mix battery types and do not mix old and new batteries.
Dispose batteries according to your state and regional guidelines.
EXERCISE COMPUTER
00:00-99:59 MIN: SEC
0.0-999.9 M (Miles) /H
0.0-999.9 M (Miles)
0.0-999.9 KCAL
BATTERY INSTALLATION & REPLACEMENT
Battery Cover
Battery
8
11
Tabla de contenido
