Operating Instructions - Phase Linear UCD200 Manual Del Usario

UCD200

OPERATING INSTRUCTIONS

Power On/Off Button (PWR)
1
Press the PWR button (1) to turn the unit on
and off when the vehicle ignition switch is on.
When the unit is off, the clock is automatically
displayed on the Liquid Crystal Display (LCD)
panel unless the ignition switch is off. If the
radio is off when the ignition switch is turned off,
the PWR button must be pressed to turn the
radio on after the ignition switch is turned on. If
the ignition switch is turned off while the radio is
on, the radio will come on automatically when
the ignition switch is again turned on.
Liquid Crystal Display Panel
2
The Liquid Crystal Display (LCD) panel displays
the frequency, time, and all activated functions,
including a 5-bar graph which depicts the signal
level.
NOTE: It is a characteristic of LCD panels
that, if subjected to cold temperatures for an
extended period of time, they may take
longer to illuminate than under normal
conditions. In addition, the visibility of the
numbers on the LCD may slightly decrease.
The LCD read-out will return to normal when
the temperature inside the vehicle increases
to a normal range.
Volume Control (AUDIO)
3
To increase the volume level, press the AUDIO
button (3a). To decrease the volume level,
press the AUDIO button (3b). The volume
will increase/decrease and the level will be
shown on display panel from a minimum of "V
00" to a maximum of "V 46". Keep the button
pressed to increase/decrease the volume
quickly. The display will automatically return to
the normal indication 5 seconds after the last
volume adjustment or when another function is
activated. These controls are also used in
conjunction with the SEL button (4) to adjust
the bass, treble, balance and fader levels.
1
RELEASE
/
PWR
3a
EQ
AUDIO
3b
SEL
4
7
Select Button (SEL)
4
The SEL button is used to select the audio
function (volume, bass, treble, balance or fade)
to be adjusted using the AUDIO buttons (3a
and 3b). Press the SEL button (4) once to set
the unit for volume adjustment ("V" will appear
on the display panel). Press the button
additional times to select bass adjustment ("BA"
on display panel), treble adjustment (TR),
balance (B), fader (F), and volume (V) again.
The display will return to the normal indication 5
seconds after the last adjustment or when
another function is activated.
2
UCD200
AM / FM / CD RECEIVER
AMS 1 2 3 4 5
SCN RPT RDM
EJECT
MON
DISP
TUNE
LOU
TRACK
BAND
MUT
6
MODE