Tabla de contenido
Idiomas disponibles

Idiomas disponibles

INSTALLATION INSTRUCTIONS
Installation Using a Kit
If your vehicle requires the use of an installation
kit to mount this radio, follow the instructions
included with the installation kit to attach the
radio to the mounting plate supplied with the kit.
1.
Wire and test the radio as described in
step 4 of "Installation Using a Mounting
Sleeve" on page 3.
2.
Install the radio mounting plate assembly
to the sub-dashboard according to the
installation kit instructions.
3.
Attach the support strap to the radio and
dashboard as described in step 6 of
"Installation Using a Mounting Sleeve" on
page 3.
4.
Replace the dashboard trim panel.

ISO Installation

This unit has threaded holes in the chassis side
panels which may be used with the original
factory mounting brackets of some Toyota,
Nissan, Mitsubishi, Isuzu, Hyundai and Honda
vehicles to mount the radio to the dashboard.
Please consult with your local car stereo
specialty shop for assistance on this type of
installation.
1.
Remove the existing factory radio from the
dashboard or center console mounting.
Save all hardware and brackets as they
will be used to mount the new radio.
ISO INSTALLATION
2.
Carefully unsnap the plastic frame from
the front of the new radio chassis. Remove
and discard the frame.
3.
Remove the factory mounting brackets
and hardware from the existing radio and
attach them to the new radio.
CAUTION: Do not exceed M5 X 6 MM screw
size. Longer screws may touch and damage
components inside the chassis.
4.
Wire the new radio to the vehicle as
described in step 4 of "Installation Using a
Mounting Sleeve" on page 3.
5.
Mount the new radio assembly to the
dashboard or center console using the
4
reverse procedure in step 1 of "Installation
Using a Mounting Sleeve" on page 3.
Removing the Radio
To remove the radio after installation, remove
the trim ring by lifting in the center and pulling it
off from either side. Insert the removal keys
straight back until they lock, then pull the radio
out. If removal keys are inserted at an angle,
they will not lock properly and will not release
the unit.
REMOVING THE RADIO
UCD200
Tabla de contenido
loading

Tabla de contenido