Installation Instructions - Phase Linear UMP401 Manual Del Usario

UMP401

INSTALLATION INSTRUCTIONS

Using the Mounting Sleeve
1. Slide the mounting sleeve off the chassis. If
it is locked into position, use the removal
tools (supplied) to disengage it.
2. Check the dashboard opening size by slid-
ing the mounting sleeve into it.
If the opening is too small, carefully cut or
file as necessary until the sleeve easily
slides into the opening. Do not force the
sleeve into the opening or cause it to bend
or bow. Check for sufficient space behind
the dashboard for the radio chassis.
3. Locate the series of bend tabs along the top,
bottom, and sides of the mounting sleeve.
With the sleeve fully inserted into the dash-
board opening, bend as many of the tabs
outward as necessary to firmly secure the
sleeve to the dashboard.
CAUTION: For proper operation of the CD
player, the chassis must be mounted within
20° of horizontal. Make sure the unit is
mounted within this limitation.
4. Place the radio in front of the dashboard
opening so the wiring can be brought
through the mounting sleeve. Follow the wir-
ing diagram carefully and make certain all
connections are secure and insulated with
wire nuts or electrical tape. After completing
the wiring connections, turn the unit on to
confirm operation (vehicle ignition must be
on). If the unit does not operate, re-check all
wiring until the problem is corrected.
5. Make sure the radio is right-side up, then
carefully slide the radio into the mounting
sleeve until it is fully seated and the spring
clips lock it into place.
BEND TABS
3
6. Secure the rear of the unit to the car body
using the mounting bolt and rubber cushion.
7. Test the radio using the Operating Instruc-
tions that follow.
SPRING CLIP
RADIO
TRIM RING
MOUNTING SLEEVE
RUBBER CUSHION
MOUNTING BOLT