Rockford Fosgate RFX Serie Instalación Y Operación página 46

S
YMPTOM
Disc will not eject
(also see error codes)
ERROR 1
(Initialize Error)
ERROR 3
(Loading Error)
ERROR 4
(Eject Error)
ERROR 6
(Transverse Error)
ERROR 7
(Servo Error)
ERROR 9
(TOC Error)
D
IAGNOSIS
Voltage applied to Yellow
wire is not between 10.8
and 16 volts or there is
no voltage present
No initialization
Mechanism is jammed
and loading motor (or
driving circuit) is defec-
tive
Foreign objects are pre-
venting the disc from
loading
Loading area in mechanism
and loading motor (or dri-
ving circuit) is defective
Foreign objects are pre-
venting disc from ejecting
Eject area in mechanism
and ejecting motor (or dri-
ving circuit) is defective
Transverse motor or
switch is defective.
Traverse area damaged
Excessive dirt or dust on
disc
Disc is warped cracked or
severely damaged
Excessive scratches on
disk
Disc is cracked, warped or
severely damaged
Laser pickup is defective
Servo unit in CDP mech-
anism is not operating
properly
– 43 –
R
EMEDY
Check battery, connections and fuses,
and repair or replace as necessary. If
voltage is above +16 volts, have the
electrical system inspected by an
authorized car service center
Press the reset button
Repair the mechanism and
loading motor (or driving circuit)
Check CDP mechanism load area by
removing faceplate and repair as nec-
essary
Repair the mechanism and loading
motor (or driving circuit)
Check CDP mechanism eject area by
removing faceplate and repair as nec-
essary
Repair the mechanism and loading
motor (or driving circuit)
Check CD mechanism motor, switch
and transverse area.
Clean disc to remove dirt or dust as
necessary
Put in a different disc!
Put in a different disc!
Put in a different disc!
Have service center repair laser pickup
Check the servo circuit area and
repair as necessary