Rotary 100 Serie Instrucciones De Instalación página 16

1. Runway Leveling Adjustments (AR14):
A. Engineer's automatic level (transit):
1. Locate the Level, at a convenient location in the shop
that allows an unobstructed view of all four corners of
the Lift's runways.
2. Follow the Level manufacturer's instructions for proper
setup of the Level. Be sure it is adjusted level in all
directions.
3. Readjust Level if tripod or Level is bumped or disturbed.
B. Raise lift approximately 28"- 32" (711-813mm). Then lower lift
until all locking latches are engaged in each column and the
runways are in full down position on locks.
C. Place the Level target on the right/front wheel turning radius
gauge.
D. Beginning with "A" position, Fig. 3, sight the Level to the target
and mark the number or the graduation on the inch scale of the
target that aligns to the cross hairs of the Level, Fig. 29.
Note: Use a pencil, marking pen or attach a paper clip onto the
target scale at the crosshair reference.
E. Next, move the target and place it on the turning radius
gauge at point "B", Fig. 30.
F. Rotate the Level and focus on the target scale.
G. Adjust the adjustment nut on the locking latch plate
adjustment stud at the top of the column at "B", Fig. 30, by
loosening the jam nut and turning adjustment nut until the
crosshairs of Level align to reference mark on the target
scale.
Target
Scale
H. Repeat steps E., F. and G., locating the target assembly
Fig. 29
16
ADJUST LOCKING LATCH BAR ADJUSTMENT NUT
at points "C" and "D" and adjusting locking latch plate
adjustment stud at each corresponding column until the
reference mark on the target scale is on the crosshairs of the
Level.
R R M B l
ack unways usT e evel
T R
o
Locking Latch Bar Adjustment Stud
Jam Nut
Bottom of Slot
Locking Latch Bar
Fig. 28
s T s , M T
ide o ide axiMuM oleRance
1/16" (1.6 ).
eaR MM
F
RonT