LG DF20WKSE Manual Del Propietário página 19

MOVING THE CONTROL PANEL (continued)
WArNiNg
w
• Disconnect power before servicing.
• Replace all parts and panels before operating.
• Be careful of the sharp edge on the frame to avoid
injury.
• Failure to follow these instructions can result in
death or electric shock.
Assemble (continued)
2 Align the hooks on the left side of the control panel
with the holes on the left side of the frame.
Keep the bottom of the control panel (A) on top of the
bottom frame (B).
Swing the control panel toward the frame, making
sure to align the three clips on the top of the control
panel with the three holes on the top of the frame.
3 Slide the control panel to the left until it clicks.
4 Insert and tighten the screw removed during the
control panel disassembly.
WArNiNg
w
If the screw is not tightened properly, the control
panel could come off .
5 Close the cap.
Control Panel
B
A
Frame
Cap
iNSTALLATiON iNSTruCTiONS
6 Attach the safety cover.
Safety
Cover
WArNiNg
w
The safety cover must be installed to avoid electric
shock hazard.
7 Install the lower cover at the top of the dryer, where
the control panel was removed. Slide the cover left
until it clicks.
8 Insert and tighten the screw removed during the lower
panel disassembly.
WArNiNg
w
If the screw is not tightened properly, the cover could
come off .
9 Close the cap.
10 Align the hooks on the top plate with the holes in the
frame.
11 Slide the plate to the left until it clicks into place.
19
Cap