Oven Operation - Forno FFSGS6275-30 Guia De Instalacion

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

• In the event of a power failure, the surface burners can be lighted manually. Hold a lighted match near a burner and turn
the knob counter-clockwise to " ". After burner lights, turn knob to the desired setting.
Burner Grills
1. The grills must be properly positioned before cooking. Improper installation of the grills may result in scratching of the
cooktop and / or poor combustion.
2. Do not operate the burners without a pan or utensil on the grills.
CAUTION
The surface of the grill is hot after use. Please allow sufficient time for the grill to cool before
cleaning.
Cooptop cleaning tips
• To prevent the cooktop from discoloring or staining, clean cooktop after each use, and wipe up acidic or sugary spills as
soon as the cooktop is cooled.
• The sealed burners of your range are not secured to the cooktop and are designed to be removed easily. Boil overs or
spills will not seep underneath the cooktop. The burners should be cleaned after each use.
Oven Light
The oven light is controlled by a push switch on the control panel.
The light can be used while cooking or cleaning the oven.
WARNING
Before replacing the oven light, make sure power is disconnected from the electrical box and
the oven is cooled completely. Disassemble the light cover and replace the light bulb with a 25-watt halogen bulb. Install
the light cover properly.
Oven Operation
Oven Ignition
The oven is equipped with an ignition system which contains safety device. To light up the oven burners, push in the oven
control knob and turn anti-clockwise to reach 250˚F position or turn clockwise to "Broil" position and hold it. You will hear
clicking noise – the sound of electric spark igniting the burner, all burners will spark. Sparking will continue until once the
knob is released. Hold the knob until you can see the burner is lighted up.
DO NOT release the knob before you can see the flame comes up.
If fail to light up the oven burner within 4 seconds, reset the oven control knob to the OFF position, repeat above operations
until the oven burner is properly ignited.
WARNING :
If fail to light up the oven burner 3 times continuously, the oven might full of the gas, then open the oven
door to allow gas dissipating before operating ignition again. Otherwise, the oven may explode and the user will get hurt.
IMPORTANT: Safety device is equipped with the oven burner. When the flame goes off by accident, the gas supply will be
shut off automatically. You need to turn the control knob back to the OFF position and ignite again.
Ignition system
When the flame is on,release the knob,the sparking will stop.
23
Tabla de contenido
loading

Tabla de contenido