The operation of any lawn mower can result in foreign objects thrown into the eyes,
which can result in severe eye damage. Always wear safety glasses or eye shields
while operating your lawn mower or performing any adjustments or repairs. We
recommend standard safety glasses or a wide vision safety mask over spectacles.
HOW TO USE YOUR LAWN MOWER
ENGINE SPEED
The engine speed was set at the factory for optimum per-
formance. Speed is not adjustable.
ENGINE ZONE CONTROL
CAUTION: Federal regulations require
an engine control to be installed on this
lawn mower in order to minimize the risk
of blade contact injury. Do not un der
any cir cum stanc es attempt to defeat
the function of the operator control. The
blade turns when the engine is running.
•
Your lawn mower is equipped with an operator presence
control bar which requires the operator to be positioned
behind the mower handle to start and operate the mower.
DRIVE CONTROL (See Fig. 5)
•
Self-propelling is controlled by hold ing the operator
presence control bar down to the handle and pulling
either drive control lever rearward to the handle. The
further toward the handle a lever is pulled, the faster
the unit will travel.
•
Forward motion will stop when either the operator pres-
ence control bar or a drive control lever are released. To
stop forward motion without stop ping engine, re lease
a drive control lever only. Hold op er a tor presence
control bar down against handle to con tin ue mowing
without self-propelling.
NOTE: If after releasing the drive control the mower will
not roll backwards, push the mower forward slightly to
disengage drive wheels.
OPERATOR PRESENCE CONTROL BAR
TO ENGAGE
DRIVE CONTROL
DRIVE CONTROL ADJUSTMENT (See Fig. 6)
Over time, the drive control system may become "loose",
resulting in decreased speed. There is a turnbuckle on
the drive control housing to increase tension on the drive
cable. Pro ceed as follows:
1. Turn unit off, disconnect spark plug wire from plug.
2. Rotate turnbuckle on drive control to increase drive
speed.
OPERATION
DRIVE
CONTROL
LEVERS
DRIVE CONTROL
DISENGAGED
FIG. 5
3. Operate mower to test drive speed. Readjust as re-
quired.
4. If condition fails to improve after the above steps
(forward speed remains the same), your drive belt is
worn and should be re placed.
ADJUSTMENT TURNBUCKLE
TO ADJUST CUTTING HEIGHT (See Fig. 7)
Raise wheels for low cut and lower wheels for high cut,
adjust cutting height to suit your requirements. Me di um
position is best for most lawns.
•
To change cutting height, pull up on adjuster lever,
move wheel up or down to suit your re quire ments
and release adjuster lever. Be sure all wheels are in
the same setting.
NOTE: Adjuster is properly positioned when lever inserts
into hole in plate.
LEVER BACKWARD
TO LOWER MOWER
LEVER
PLATE
TO CONVERT MOWER
Your lawn mower was shipped ready to be used as a
mulcher. To convert to bagging or discharging:
REAR BAGGING (See Fig. 8)
•
Lift rear door of the lawn mower and place the grass
catcher frame hooks onto the grass bag brackets.
•
To convert to mulching or discharging operation,
7
remove grass catch er and close rear door.
Use ear pro-
t e c t o r s
avoid damage
to hearing.
FIG. 6
LEVER
FORWARD
TO RAISE
MOWER
FIG. 7
t o