Trim
1.
Remove lower trim from protective packaging. Rotate
side clips (3) outwards (Figure 5.). Remove LED Engine
from protective packaging.
2.
Insert LED engine on to trim assembly. Align post on
LED engine with slot on trim assembly (Figure 6.).
3.
Rotate side clips (3) into place to securely attach trim
assembly to LED engine (Figure 7 .).
4.
Plug in the luminaire quick disconnect on the module
(Figure 8.).
5.
In HCC4 and HCC6 cylinders find the green tether
inside cylinder and attach it to the heatsink screw boss,
using the thumbscrew provided on heatsink (Figure 9.).
6.
For HCC8 cylinders attach tether to module using
bracket provided and the spring clip on end of the
tether (Figure 10.).
7 .
Install the LED Engine and trim assembly by inserting
the torsion springs into the spring receivers located
inside the housing (Figure 11.).
Figure 5.
Figure 6.
Wiring Diagrams and Instructions – HCC4, HCC6, HCC8 & Commercial LED Rough-In
Figure 7.
Figure 8.
Thumb Screw
Tether
Figure 9.
Figure 10.
COOPER LIGHTING SOLUTIONS
Mating Bracket
IB517029ML
Installation instructions
Tether
3