NSK PRESTO AQUA II Manual Del Usuario página 3

1. Name of Each Portion
1 2 3 4 5 6
11 12 13 14
18
16 17 19 20
25
26
27
1
PRESTO AQUA II Control Unit 10 Water Filter Set
2 Filter Inspection Window 11 Foot Pedal
3 Pressure Gauge 12 Plumbing Hose
4 Regulator Knob PRESTO AQUA Handpiece
13
5 Chip Air Adjustment Knob 14 Coupling Joint
6 Water Adjustment Knob 15 Handpiece Hose
7 Water ON/OFF Switch 16 Bottle Attaching/Detaching Switch
8
Water Supply Bottle 17 Water Mode Select Switch
9 Handpiece Connector 18 Foot Pedal Connector
2. Specifications
-1
Speed 320,000min
Proper Air Supply Pressure 0.25~0.3MPa
ø16.6 ( D ) X 136.6 ( H ) mm
Handpiece Dimensions
104g ( including coupling joint )
Handpiece Weight
Control Unit Dimensions W235 X D139 X H182 ( mm )
Control Unit Weight 1.9kg
22
7 8 9 10
23
24
15
21
19 Hose Stopper
20 Water Connector
21 Plumbing Connector
Bur-inserting Wrench
22
23 Rotor Shaft Nut Wrench
24 Air Supply Connector
Chuck Release Ring
25
26 Cartridge
27 Cartridge retainer
2
3. Installation Procedures of Each Portion
3-1 Installation of Plumbing Hose
Push the plumbing hose into the plumbing connector
located at the regulator on the left-hand side of the
control unit until it is securely set to make connection as
shown in Fig. 1. Check if the hose is securely installed by
slightly tugging it after connection. Connect the other end
of the plumbing hose to the air line. At this time, use the
attached connector if necessary.
CAUTION
• Push the plumbing hose into the connector until it is securely set. Otherwise, air may leak.
• Pushing the white ring, on the plumbing connector, gently remove the tube.
3-2 Installation of Foot Pedal
Loosen and remove the hose stoppers (two) from the foot
pedal connectors on the back of the control unit, and
insert them into the foot pedal hoses. At this time, insert
the hose stoppers so that their screws come outside
(control unit side).
Insert the "1"-marked end of each hose according to the
instructions on the label. After insertion of both hoses,
securely tighten the hose stoppers (Fig.2).
3-3 Installation of Handpiece
Install the handpiece hose to the handpiece connector on
the front face of the unit (Fig.3).
Install the handpiece hose to the coupling joint (Fig.4).
And then, install the handpiece by pulling the ring of the
coupling joint (Fig.5).
White Ring White Ring White Ring
Plumbing Connector Plumbing Connector Plumbing Connector
Plumbing Hose Plumbing Hose Plumbing Hose
Foot Pedal Connector Foot Pedal Connector Foot Pedal Connector
Hose Stopper Hose Stopper Hose Stopper
Fig. 4
3
Fig. 1
Fig. 2
Fig. 3
Fig. 5