Smartwares HA788GSM Manual De Instrucciones página 5

Step 14 – Moun�ng the system
Alarm Panel
Selec�ng a suitable loca�on:
Mounted the alarm panel close to the door which you normally use to enter/exit your

house.
Note that the Alarm panel requires a power outlet to func�on properly.

Ensure the loca�on selected a good GSM signal. You can do this by cross checking the signal

bar on your phone at that loca�on.
The panel must not be co-located or operated in conjunc�on with any other nearby

transmi�er or antenna.
1. Remove the back panel moun�ng bracket of the
GSM and mount the bracket on the wall using wall
anchors and screws.
2. Once secured, ensure the power connec�vity and
rea�ach the alarm panel to the secured moun�ng
bracket.
Door/Window contact
If possible, locate sensors within 100 �. (30m) of the panel. While a transmi�er may have a range
of 350 �. (106 m) or more out in the open, the environment at the installa�on site can have a
significant effect on transmi�er range
1. Mount the sensor on the door frame and the
magnet on the door. If the sensor is used on
double doors, mount the sensor on the least-
used door and the magnet on the most-used
door.
2. Place sensors at least (1.5 m) above the floor for
best transmission range
3. Make sure the alignment arrow on the magnet
points to the alignment mark on the sensor.
4. Avoid moun�ng sensors in areas where they will
be exposed to moisture or high temperature.
5. Use spacers (not included) to keep sensors and
magnets away from metal or metallic surfaces
such as foil wallpaper.
PIR Mo�on Sensor
The recommended position for a PIR Detector is in the corner of a room mounted at a height between
1.8 and 2m. At this height, the detector will have a maximum range of up to 10m with a field of view of
Keep sensors within 30 m (100 �) of alarm panel.
110° (see figure below).
3
9 7 5 1
1. Fix the mo�on sensor on the wall by using the
adhesive tape provided.
2. If you need to drill it on the wall, remove the rear
cover and drill through the rear cover. Drill guides
are provide for flat mount or corner mount (see
below)
3. Once the back cover is secured rea�ach the main
body of the sensor to the back cover.
Corner mounted
Drill for corner monuting
Drill for flat wall monuting