Smartwares HA788GSM Manual De Instrucciones página 3

Step 4 – Record an Alert voice message
1. The alarm panel's built in microphone can record your message.
Enter on the alarm panel.
1234
2. When record bu�on flashes green clearly say a brief alert message into the microphone.
3. When light stops flashing the panel will play back the alert message.
Step 5 – Test the remote control
Note: Included accessories are pre-binded with the alarm panel at
the factory.
1. Test communica�on link by pressing Disarm
2. Red indicator on the remote will light along with a long beep at the
panel.
Important : If the siren goes off any�me during the set up, press the
Disarm bu�on on the remote to immediately turn off the siren
Step 6 – Test the RFID key tag
1. RFID tags can disarm the system.
2. Arm the system using remote control, check ARM icon lights up
3. Hold the RFID tag near the panel a�er arming the system.
4. A long beep followed by the Disarm indicator light will display.
5. Several RFID tags can be added and each can have a different
number.
Step 7 – Tes�ng the PIR mo�on sensor
1. Put the alarm panel to test mode by :
1234 03
The icon will flash when in this mode.
2. Press and release the tamper switch inside the PIR un�l the
panel makes a chime sound.
3. Place the rear cover back on the PIR.
on the remote
Step 8 – Test the door / window contact
1. Leave the system in Test Mode
2. Press and release the tamper switch on the back of the sensor
�ll the panel makes a chime sound.
Step 9 – Smartphone App Setup
With the HA788GSM App you can have remote access to the GSM alarm system from your
smartphone. You can set your alarm system to Arm/Par�al Arm/Disarm easily and receive alert
messages on your smartphone when events occur.
Important: Make sure you're installing the App on the same phone you used in Step 2.
1. From Google Play/ Apple Store, search for 'Everspring GSM Alarm System' App and install it.
2. Create a new system by selec�ng a name, then enter the phone number of the SIM card you
inserted inside the panel.
3. Select the newly created system from the home screen ( figure D)
4. Then click on the status bu�on to know the current status of the system. (figure E)
5. An op�on to send system status via SMS will appear. Select it. (figure F)
6. An SMS will be sent to the host's (owners) cellphone. (figure G)
D E F G