Technical Data - Hilti DGH 130 Manual De Instrucciones

3.8 Temperature-dependent motor protection
The temperature-dependent motor protection system monitors current input and motor temperature and
thus prevents the power tool overheating.
If the motor is overloaded through application of excessive working pressure, the power tool's performance
drops noticeably or it may stop completely. A standstill should be avoided. No specific value can be given
for the permissible overloading limit for the power tool as it depends on motor temperature.
3.9 Keyless
The product has a Keyless system for no-tools installation and removal of the cup wheels.
4

Technical data

For rated voltage, rated current, frequency and/or input power, refer to the country-specific type
identification plate.
If the device is powered by a generator or transformer, the generator or transformer's power output must be
at least twice the rated input power shown on the rating plate of the device. The operating voltage of the
transformer or generator must always be within +5 % and -15 % of the rated voltage of the device.
Weight
Rated speed
Speed (controlled)
Disc diameter
Disc thickness
4.1 Noise information and vibration values in accordance with EN 62841
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the total
working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
Noise information
Sound power level (L )
WA
Uncertainty for the sound power level (K
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Vibration information
Vibration emission value, diamond cup wheel (a
Vibration emission value, fine-grinding (a
Uncertainty (K)
18 English
Printed: 23.07.2019 | Doc-Nr: PUB / 5504888 / 000 / 00
)
WA
)
pA
)
pA
)
h
)
h
DGH 130
2.54 kg
12,000 /min
3,000 /min ... 8,700 /min
130 mm
4 mm
96.3 dB(A)
3 dB(A)
85.3 dB(A)
3 dB(A)
3.6 m/s²
3.1 m/s²
1.5 m/s²
2204296
*2204296*