Basic Steps In Making Bread - West Bend Just For Dinner Manual De Instrucciones

YEAST is a living organism, which, through fermentation feeds on carbohydrates in
flour and sugar to produce carbon dioxide gas that makes the bread rise. Fast
rising or bread machine yeast must be used in your bread maker for best
results in the 45-minute cycle. Do not use active dry or compressed yeast, as
poor results will be obtained.
A ¼-ounce package of fast rising or bread machine yeast contains 2¼ teaspoons,
the exact amount needed when making scratch recipes. Yeast can also be
purchased in glass jars so you can measure the exact amount needed. Once jar is
opened, keep refrigerated. Always make sure yeast is fresh and has not passed the
"use by" date.
SPECIAL NOTE ON CINNAMON AND GARLIC: Adding too much cinnamon or
garlic can affect the texture and size of the loaf obtained. Cinnamon can break down
the structure of the dough, affecting height and texture. Too much garlic can inhibit
the yeast activity. Use only the amount of cinnamon and garlic recommended in the
recipe.
Always clean your new appliance thoroughly before using. Refer to "Cleaning
Your Breadmaker" section.
1. Position knead bar onto shaft in bottom of pan, matching hub shape with shaft
shape. You may need to twist bar slightly to drop in place. Make sure knead
bar is pushed down onto shaft all the way.
2. Add ingredients to pan in order listed in recipe, liquids first, then the butter or
margarine, next the dry ingredients and finally the yeast. It is best to level the
dry ingredients before adding the yeast.
3. Postion pan into bread maker and turn in direction of arrow (counterclockwise)
to lock in place. If pan does not lock securely, remove and reposition until
secured. Pan must always be locked in place for bread maker to function.
Close cover.
4. Plug bread maker cord into a 120 volt AC electrical outlet ONLY. Alert will
sound. Press Bread Select button for type of bread being made. Press
Start/Stop once to turn machine on. Green "operation" light on control panel
will glow.
After bread maker has been turned on, programmed setting cannot be changed.
To change setting, hold Start/Stop button down until alert sounds and green
"operation" light goes out. Then program control as desired and turn back on.
The bread making process will begin and green "operation" light will glow. The
dough will knead, rise and bake all in 45 minutes.
A few minutes before the bread starts to bake (22 minutes after machine is
turned on), an alert will sound to perform crust treatment if desired (see pg. 10).
5. When bread is done, alert will sound and red light for "keep warm" will glow on
control panel. Turn bread maker off by holding Start/Stop button down until alert
sounds and red "keep warm" light goes out. Unplug cord from electrical outlet.
It is best to remove bread immediately for a crispier crust. Open cover and
remove pan using oven mitt or hot pad, turning to right, (clockwise) to unlock.
If bread is not removed right after cycle is complete, it will automatically go into

BASIC STEPS IN MAKING BREAD

8