Final Installation Checklist - Maytag 9700 Serie Instrucciones Para La Instalación

NOTE: Keep the leg extension at a minimum to prevent excessive vibra-
tion. The farther out the legs are extended the more the washer will ibrate
and possibly walk.

FINAL INSTALLATION CHECKLIST

Instruction and Installation Kit have been removed from tub.
Shipping bolts and spacers have been removed.
Washer is plugged into electrical outlet and is properly grounded.
Water hoses are connected to the faucets with inlet screens and washers.
Water is turned on and checked for leaks at faucet and water valve connections on back of washer.
Drain hose is properly located into drain facility and is not collapsed or damaged.
Washer has been properly leveled. All legs should be firmly on the floor and leveling leg lock nuts tight-
ened up against the bottom of the washer base frame.
Washer fills properly on all temperature selections.
Test for proper operation by running the washer through a complete cycle.
COLD WEATHER STORAGE
The following precautions should be taken if a washer is to be stored, after use, where it would be subject
to freezing conditions.
1. Turn off the water supply, then remove the inlet hoses from the facets.
2. Place the end of the inlet hoses into a bucket or container. Select a fill cycle and energize the water valve
by selecting a warm water setting. A few seconds of fill is sufficient to empty the inlet hoses.
3. Disconnect from electrical supply.
4. Lower the drain hose to floor level and tilt washer backwards to remove water from the drain hose and
pump.
8