Honeywell LCBS Instrucciones De Instalación página 4

LCBS CONNECT WALL MODULE
SPECIFICATIONS
Operating Temperature: 32°F to 122°F (0°C to 50°C)
Shipping Temperature: -4°F to 150°F (20°C to 65°C)
Relative Humidity: 5% to 95%, Non-condensing
Related Parts
Parts that are commonly used with the LCBS Connect
controller and wall module are shown in Table 2.
Table 2. Compatible Sylk Sensors.
Sylk
Device
YCRL6438SR1000 Controller and Wall
Module Pack
TR40 Sylk Wall Module with
Temperature Sensor
TR40-H Sylk Wall Module with
Temperature & Humidity
Sensors
TR40-CO2 Sylk Wall Module with
Temperature & CO2
Sensors
TR40-H-CO2 Sylk Wall Module with
Temperature, Humidity
& CO2 Sensors
C7400S1000 Sylk Enthalpy Sensor
50028399-0001 Wall Plate
By using this Honeywell literature, you agree that Honeywell will have no liability for any damages arising out of your use or
modification to, the literature. You will defend and indemnify Honeywell, its affiliates and subsidiaries, from and against any
liability, cost, or damages, including attorneys' fees, arising out of, or resulting from, any modification to the literature by you.
Home and Building Technologies
In the U.S.:
Honeywell
715 Peachtree Street NE
Atlanta, GA 30308
customer.honeywell.com
Sylk
Description Address(s)
N/A
3, 4, 5, 6
3 Only
3 Only
3 Only
8, 9
N/A
Approvals
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and
receiver.
— Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
This Class B digital apparatus complies with Canadian
ICES-003.
Cet appareil numérique de la classe B est conforme à la
norme NMB-003 du Canada.
This device complies with Industry Canada license-
exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause
interference, and (2) this device must accept any
interference, including interference that may cause
undesired operation of the device.
® U.S. Registered Trademark
© 2017 Honeywell International Inc.
31-00084EFS—01 M.S. 10-17
Printed in United States