CHIEF iC Serie Instrucciones De Instalación página 14

iCLPFA3
4
6
4
C x2
6
C x2
4
GA, GB
14
x4, x6, x8
2 5
EB, FB
3
EA, FA
3
1
NOTE: You may
need to switch
brackets for some
mounting hole patterns.
x4, x6, x8
2 5
EB, FB
3
EA, FA
3
1
INSTALL BRACKETS TO DISPLAY
(for mounting patterns larger than 200x200mm)
1. Lay display face down on protective surface.
NOTE:
For some mounting hole patterns, it will be
necessary to switch the left and right brackets.
CAUTION:
Using screws of improper diameter may
damage your display! Proper screws will easily thread into
display mounting holes.
2. Select screw diameter by examining hardware bags "A"
through "D" (8mm, 6mm, 5mm, or 4mm) and comparing
with mounting holes on display.
3. Select washers:
• 6mm and 8mm diameter screws: Use flat washer
(FB) and shoulder washer (FA).
• 4mm and 5mm diameter screws: Use flat washer
(EB) and shoulder washer (EA).
4. Select spacers:
• If mounting holes are not recessed, and both
brackets (C) can lay flat against display, then no
spacers are required.
• If mounting holes are recessed, or if protrusions
prevent brackets (C) from laying flat, then spacers
(GA or GB) must be used. Select shortest spacer
which will provide adequate fill. All spacers must be
same length.
CAUTION:
Using screws of improper length may
damage your display! Proper screws will have adequate
thread engagement without contacting bottom of display
mounting holes.
5. Select screw length:
• Using your hand, insert SHORTEST length screw of
selected diameter (AA, BA, CA, or DA) through
selected flat washer (EB or FB), selected shoulder
washer (EA or FA), bracket (C), selected spacer (GA
or GB, if required), into display mounting hole. Do
NOT thread screw into hole at this time.
• Proper screw length requires base of screw head to
protrude above flat washer a distance equal to or
greater than the screw diameter. If screw length is
inadequate, insert longer screw. Select shortest
screw which will protrude the required distance.
6. Carefully install selected screws, but do NOT tighten
screws at this time. Ensure all applicable display
mounting holes (4, 6, or 8) are used.
Installation Instructions