Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1.2 - INSTALLING THE BASE ON THE WALL
Installing the device: INDEPENDENT - FIXED
ATTENTION: INSTALLATION MUST BE PERFORMED AFTER
SECTIONING THE MAINS SUPPLY - 230 V .
For installation, it is necessary to separate the front part, complete with
electronic card, from the base.
!
First on one side and then on the other, insert a screwdriver in the slots
located on the sides of the product, exerting light pressure on the locking
catch, then, with a small forward rotation of the screwdriver (as shown in
figure 3.i), lift the front.
!
Remove the front from the base (the resistance to removal is due to the
coupling pin on the terminal strip) fig. 4.i .
From the base, remove the parts prepared for the passage of the connection wires shown in fig. 5.i.
!
Pass the connection wires through the opening you have made.
!
Attach the base to the wall (or built-in box), with 2 screws using the pairs of holes
!
Make the electrical connections to the terminals located on the base as shown in the next chapter.
D = Catches for locking the
front to the base
Removable area for the
passage of wires
(Installation with built-in box)
~
(
)
C
B
A
A
B
C
D
D
7
8
9
10 11 12
1
2
RESET
2
1
RESET
(
A-A, B-B, -C-C
)
provided (fig. 5.i).
Removable areas for
installation with trunking
system.
ON
E
N
Fig. 3.i
ON
Fig. 4.i
Fig. 5.i
5
Tabla de contenido
