Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2.6 - OPERATION
The transmitter control heat regulation and send command and control signals to the receiver, which
s
makes them operational
. The operational s
commands, a short time apart, and by an effective self-diagnostic system.
Signals during normal operation:
!
ON LED: lit
!
LED 1
and/or
LED 2
: on with control activated, off with control deactivated
!
PUMP LED
: on only in concomitance with
!
LED VMETER
: 1, 2 or all the
2. - CHECKING THE INTENSITY OF THE RECEIVED SIGNAL - VMETER
7
ON THE TRANSMITTER
!
Activate the
"check the intensity of the radio signal mode",
ON THE RECEIVER
!
The
intermittent LED 1
or
LED 2
the transmitter.
!
The
3 LEDs
o the
n
VMETER
indicate the intensity of the radio signal received, as illustrated in the
figures to the side.
N.B.: Verification mode on the transmitter automatically terminates 3
minutes after activation.
If you wish to interrupt the verification, deactivate
transmitter, as explained in the instruction manual.
ATTENTION: even in
"normal operation"
stored):
!
1
2
Press the
(o
r
) key
received for 5 seconds.
s
ecurity
of the control is assured by the double sending of
LED 1
and/or
LED 2
LEDs
light up briefly with each radio signal received
indicates the coupling condition of
,
together with the audible signal
"Verify"
mode
it is possible to check the intensity of the last radio signal received (the last signal is always
for about 2 seconds, then let go: the
as explained in the specific chapter of the transmitter manual.
SIGNAL INTENSITY
LOW
,
ON
ON
on the
LEDs
o the
n
VMETER
will show the intensity of the last signal
Fig. 13
ON
Command
Command
activated
deactivated
MEDIUM
HIGT
ON
Fig. 14
E
N
13
Tabla de contenido
