Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2.2 - NEW DEVICE
When turned on, the receiver has only the
N.B.:
there may be a weak lighted signal on the
E
of radio interference.
N
2.3 - TEMPORARILY FORCING THE STATE OF THE CONTROL OUTPUT
A) TRANSMITTER NOT YET COUPLED OR NOT ACTIVE
!
Hold down the
1
(o
LED is steady on (fig.4). Also the pump (or burner) command is activated.
The control will remain activated for 5 minutes, at the end of which, an audible signal will continue for
its imminent deactivation (fig.5) f you wish to keep it active, press the
otherwise, when the signal ceases, the control will be deactivated.
Fig. 4
1
2
Canceling the temporary forcing of the control
!
Briefly press the
"RESET" key
temporary forced control is cancelled (fig.6).
N.B.: Before performing this operation, consult
paragraph 3.0
"
RESET
"
.
B) TRANSMITTER COUPLED AND HEAT REGULATION ACTIVE
The above-indicated operations can also be performed, using the same methods, during normal heat regulation operation; in this case,
the temporary forced control will cause the transmitter to be excluded and the reversal of the command status: if active, it will be
deactivated and vice versa. During the forced state, the corresponding
10
ON LED
lit
(fig. 3)
lower LED
u
2
) key
until there is a brief audible signal, then let go: the control is activated and the corresponding
. I
1
2
; when released the
.
of the
VMETER
, due to the presence
(ex. to test the system)
1
(o
r
2
) key
again while the audible signal is sounding;
5 minutes
1
2
RESET
Fig. 6
key (
1
o
r
2
)
is not functional.
ON
:
5 seconds
to alert the operator of
1
2
5 s
Fig. 5
1
2
Fig. 3
Tabla de contenido
