Component Description - Werner SRS-72 Instrucciones De Montaje

ASSEMBLY INSTRUCTIONS FOR STACKING ADDITIONAL UNIT

COMPONENT DESCRIPTION

(2) Guard Rail Panels
(4) Lock Pins
(4) 18" Outriggers
(8) Snap Pins
(4 From additional unit)
(8) 5" Casters
(4 From additional unit)
If the desired platform height is
between 6' and 11' 6" additional
unit is required.
WARNING:
STEP 1 Install caster (E) into outrigger (C) and
secure with snap pin (D). Repeat for
remaining 3 outriggers. See Fig. A.
STEP 2 Install outriggers (C) by clamping to
end frames perpendicular to the side
braces. Clamps must be tight and
casters must make contact with the
floor. Set caster brakes. See Fig. B
STEP 3 Install end frames of upper unit onto
end frames of base unit (See Fig. C).
Insert 4 snap pins (D) to secure
scaffold units. Attach 2 side braces to
upper end frames at desired platform
height. Place platform so that it is fully
seated and level in both side braces.
Be sure the deck pins are in the
engaged position.
STEP 4 Install guard rail panel into side brace
sockets and secure with lock pin. (See
Fig. D) Guard rail gate must swing
inward above platform. Repeat for
other side.
WARNING:
A
B
C
D
E
• When stacking second unit, outriggers and guardrails are required.
• Do not stack more than 2 units high.
• All scaffolds must be restrained from tipping.
• Guard rail gate must swing inward above platform.
• Make sure each scaffold level has both side braces installed.
• Follow all applicable ANSI & OSHA guidelines along with state and
local codes for the use of this product
SEE ILLUSTRATION
A
E
Fig. A
Snap
Pin
Fig. C
B
D
C
Tighten
End
Frame
Outrigger
Fig. B
Side
Brace
Socket
Fig. D