Making An Espresso - Krups AUTOCAPUCCINNO Serie Manual De Instrucciones

n Press the "2 cups" button and let the water run out into a container (fig.9). Repeat this operation 5
times.
n If necessary, stop the operation by pressing the "2 cups" button (fig.9) to empty the container and
resume the operation.
n Empty the container and unlock the filter holder: press the "OPEN" button on the filter holder and turn
it to the left (fig.10).
- RINSING OUT THE STEAM CIRCUIT.
Before using the steam function for the first time, the steam circuit should be cleaned.
n Fill the water tank
n Turn the appliance on by pressing the
n Place a recipient underneath the steam nozzle.
n Press the
button, it starts to flash.
n When the button has stopped flashing, turn the steam switch to position
steam is formed.
n Keep the steam production going for at least 30 seconds.

5. MAKING AN ESPRESSO

In order to extract the maximum flavor from the beans, this machine pre-infuses each cup. The pump works
for 3 seconds, pauses for 3 seconds, and then continues until the cup is finished.
PREHEATING THE ACCESSORIES
For the best results, we recommend that you preheat the accessories (filter holder and cups) without
espresso ground coffee. To do so:
n Fill the water tank and turn the machine on. (fig.1, 2, 3 and 4).
n Put the filter holder in place, place the cups below.
As soon as the appliance reaches the required temperature, the "on/off" light stops flashing and the "1
cup" and "2 cups" buttons light up.
n Then press the "1 cup" or "2 cups" button (fig. 8 or 9).
n Once the cup or cups are filled with hot water, remove them.
n Unlock the filter holder: press "OPEN" while turning the filter holder to the left and remove it from the
machine. (fig.10).
WITH GROUND COFFEE
The type of coffee you choose will determine the strength and taste of your espresso. Always
use espresso ground coffee. Do not use instant coffee, cafetiere coffee or filter coffee.
n Fill the water tank and turn the machine on (fig. 1, 2, 3 and 4). During the preheating of the appliance,
the light flashes.
n Using the measuring spoon, place the espresso ground coffee in the filter holder: one spoon (full to the
brim) per cup (fig.5).
n Remove any excess espresso ground coffee from the edge of the filter.
Important: Do not tamp the coffee down in the filter holder. The coffee is automatically
tamped using the KTS "Krups Tamping System".
n Insert the filter holder in the device by turning it to the right as far as it will go, up to the stop
(fig.7).
n Put one or two cups under the filter holder.
As soon as the appliance reaches the required temperature, the "on/off" light stops flashing and the "1
cup" and "2 cups" buttons light up.
n Then press the "1 cup" or "2 cups" button (fig. 8 or 9).
button.
English
and let the water run until
6