Care And Maintenance; Blade Unit - Russell Hobbs 20230-56 Instrucciones

3. Don't fill past the 1500ml mark. If you do, the contents may force the lid off when you start
the motor.
4. Replace the lid.
5. Fit the cap to the hole in the lid, and turn it anti-clockwise to lock it.
6. Don't run the appliance without fitting the cap.
7. Check that the speed control is set to Y.
8. Put the plug into the power socket.
9. Turn the speed control to the speed you want (1 = low, 3 = high).
10. Turn the speed control back to Y to turn the motor off.
11. Turning the speed control anti-clockwise to Y will give you a short burst at high speed. In
this direction, the knob is spring-loaded. When you let go, it'll return to Y.
12. The light will change colour as the speed changes.
1
2
3
Y
13. To add ingredients while the blender is working, remove the cap, pour the new ingredients
through the hole, then replace the cap.
FINISHED?
• Switch the appliance off (Y) and unplug it.
Turn the jug to align the d with the U to unlock it, and lift it off the motor unit.
•
CRUSHED ICE
Before using the appliance to crush ice, make sure it's clean, and rinse it out thoroughly.
The slightest trace of detergent may affect the taste of the crushed ice, and will flatten any drink
to which it is added.
For best results, full the jug with between 150ml and 500ml of ice cubes.
Put the lid on the blender, then:
Turn the speed control to Y for a second or two, then release it.
1.
2. Check the results, and adjust.

CARE AND MAINTENANCE

1. Switch the appliance off (Y) and unplug it.
2. Wipe the outside of the motor unit with a clean damp cloth.
3. Hand wash the removable parts.
` You may wash these parts in a dishwasher.
If you use a dishwasher, the harsh environment inside the dishwasher will affect the surface
finishes.
The damage should be cosmetic only, and should not affect the operation of the appliance.

BLADE UNIT

You may wish to remove the blade unit for cleaning.
1. Remove the lid.
2. Sit the jug upside down.
3. Unscrew the jug base and lift it off.
4. Carefully, lift the blade unit out of the jug. Handle only the plastic – don't touch the metal
parts.
5. Lift the seal away from the blade unit.
6. Wash the seal and blade unit in warm soapy water, rinse, and air dry.
7. Replace the seal round the blade unit.
8. Replace the blade unit in the jug.
9. Turn the jug base upside down, and screw it on to the bottom of the jug.
Blue
Purple
Green
Red
Purées
Smoothies
Soups/ other
Ice crushing/ smaller batches
4