Home Decorators Collection 7984HDCAN Guía De Uso Y Cuidado página 7

Assembly - Standard Ceiling Mount
1
Preparing for mounting
□
Remove the canopy ring (II) from the canopy (C) by turning
the ring (II) counterclockwise until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (GG) located in the "L
shaped" slots.
□
Remove and save two canopy screws (HH) in the round
holes. This will enable you to remove the mounting
bracket (A).
A
HH
3
Assembling the fan
WARNING: Failure to properly install the locking pin (FF) could
result in the fan becoming loose and possibly falling.
□
Loosen, but do not remove, the setscrews (JJ) on the collar on
top of the fan-motor assembly (E).
□
Align the holes at the bottom of the ball/downrod assembly (B)
with the holes in the collar on top of the fan-motor assembly (E).
□
Carefully insert the hanger pin (EE) through the holes in the
collar and ball/downrod assembly (B). Be careful not to jam
the hanger pin (EE) against the wiring inside the ball/downrod
assembly (B).
□
Insert the locking pin (FF) through the hole near the end of the
hanger pin (EE) until it snaps into its locked position.
□
Re-tighten the setscrews (JJ) on the collar on top of the fan
motor assembly (E).
2
Routing the wires
□
Route the wires exiting the top of the fan motor assembly (E)
through the center of the canopy ring (II). Make sure the slots
on the canopy ring (II) are on top.
□
Insert the ball/downrod (B) through the canopy (C) and slide
the decorative motor collar cover (D) onto the end of the
ball/downrod (B). Make sure the slots on the canopy (C)
are on top. Route the wires exiting the top of the fan motor
assembly (E) through the downrod (B) as shown.
GG
C
II
7
EE
JJ
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
C
II
B
D
E
C
II
B
D
FF
E