Master Forge 0050772 Manual De Instrucciones página 15

CONVERSION INSTRUCTIONS
Adjust valve model control screw
1. Pull all the knobs off of valve stems.
(Fig. 36)
2. Adjust the screw in each valve hole using
the slotted screwdriver (C).
In NG configuration turn the screws
clockwise until tightened. (Fig. 37)
Make sure to completely tighten the
screws. Failure to tighten the screws will
result in the low heat setting working
improperly (as illustrated in Fig. 37).
After making all of the conversions, return heat tents to burner box, followed by the grid and
warming rack.
36
37
valve hole
Lowes.com/masterforge
15